JVC HA-D5T (01) PDF MANUAL

JVC HA-D5T (01) PDF SUMMARY:

How do I charge the earbuds?

Put the earbuds into the charging case, the earbuds will be charged automatically. The red status LED light will be on during charging and will turn off when fully charged.

How do I charge the charging case?

Use a Type-C cable connected to a USB charger (DC SV-1A).

What are the steps for dual earbuds pairing for the first time?

Take out both earbuds from the charging case at the same time. The LED light on both earbuds will flash blue & red at first. One of the earbud’s LED light will turn off after 2 seconds. This indicates that both earbuds are ready to pair. Turn on the Bluetooth on your device and search for a new device, then select “JVC HA- ST” to connect.

How do I reconnect the earbuds?

The earbuds will automatically try to reconnect with the last paired device after restarting. If not, put the earbuds back in the charging case and try again or connect manually.

What should I avoid when using the earbuds?

• Never disassemble or modify your earbuds for any reasons to avoid any damages and danger.
• Do not store the earbuds and charging case in extreme temperatures (under 5°C or over 35°C).
• Avoid using the indicator close to the eyes of children or animals.
• Do not use these earbuds during a thunderstorm to avoid irregular function and increased risk of electric shock.

What are the common problems and solutions if the mobile phone cannot find the wireless earbuds?

• Check whether the earbuds power is switched On or not.
• Does the status LED light flicker red & blue alternatively? If the wireless earbuds still haven’t been found after switching power On, please restart both the earbuds and the Bluetooth search on your phone.

What should I do if there is something wrong with the wireless earbuds while using them?

• Try to reconnect with the mobile phone after turning it off and restarting the earbuds.
• Check the charging status of the earbuds by putting them into the charging box until the red LED indicator is on. Then take them out and let them try to reconnect with the mobile device.

What are the solutions if the wireless earbuds always disconnect or make noise when connected to the mobile device?

• The wireless earbuds power status is low, please recharge it.
• There is an obstruction between the mobile device and the wireless earbuds, or the wireless distance is beyond signal range. Please do not cover the wireless earbuds with your hands in order to maintain the continuous stability of the signal; please try to keep the wireless earbuds and the mobile device in the same direction.

What should I do before using the earbuds?

Read the manual carefully and keep it for future references.

Do the earbuds need to be fully charged prior to first-time use?

Yes, the earbuds need to be fully charged prior to first-time use.

What should I do if the earbuds are left unused for over two weeks?

If the earbuds are left unused for over two weeks, please recharge them periodically.

What kind of chargers should I use for the earbuds?

Use the chargers made by a qualified manufacturer.

What should I do if the earbuds can’t be found by your phone?

Check whether the earbuds are in pairing mode and connect them.

What are the functions of the Multi Function Button (MFB)?