ISCOOTER I10 PRO (01) PDF Document

Press and hold the power button for about 2 seconds to turn on/off the ISCOOTER i10 Pro electric scooter.

Tip: The scooter will automatically shut down when it is not used for 10 minutes.

After turning on the ISCOOTER i10 Pro electric scooter:

Press the headlight/taillight button to turn on/off the headlight and taillight.

Press the headlight/taillight button three times to switch the system of units between imperial and metric.

Press the headlight/taillight button four times to switch between zero start (default) and non-zero start.

Press the headlight/taillight button five times to enable/disable cruise control (keep a constant speed for 5 seconds and the scooter will move at this speed without pressing the throttle).

Press the speed switch button to switch the speed mode.

Push the turn signal switch to the left or right to turn on the left or right turn signal light respectively.

Press or hold the horn button to sound the horn.

The Speed Modes for the ISCOOTER i10 Pro electric scooter are:

Mode 1: 9 mph Top Speed

Mode 2: 22 mph Top Speed

Mode 3: 28 mph Top Speed

Check your ISCOOTER i10 Pro electric scooter for any loose parts or screws, flat tires, signs of damage, or excessive wear before every ride. Stop operation immediately and contact your place of purchase if something does not feel right.

Also check the scooter before every use. When you note loose parts, low battery alerts, excessive wear, strange sounds, malfunctions and other abnormal conditions, stop riding.

Always wear a helmet and protective safety equipment.

Wear closed shoes without heels and ensure your laces are tied.

Start riding slowly to familiarize yourself with the operation of your ISCOOTER i10 Pro electric scooter. Start in the slowest speed mode and slowly try out the brakes. Always slow down when riding over bumps or on rough road conditions. Slightly bend your knee to better adjust these surfaces.

Do not use your electric scooter in heavy rain, or on surfaces covered by more than 0.5 inches of water. Do not submerge the scooter in liquid or let any liquid near the battery or electrical components.

Once riding in public space, you are subject to the risks faced by all traffic participants just like when you are riding a bike.

Other traffic participants may not obey traffic regulations or may ride carelessly.

The faster you ride your scooter, the longer it will take you to stop.

The scooter may slip on slippery surfaces leading to subsequent injuries to the rider. Pay special attention crossing train tracks and/or when it is wet.

Always use caution, adapt your speed to road and traffic conditions and keep distance from other traffic participants.

Watch out for pedestrians. Do not use your scooter in any way that could harm pedestrians. Slow down when you are passing them to avoid accidents.

You must follow all local traffic rules and regulations.

Do not accelerate when you go downhill.

Do not press the accelerator when you’re walking the scooter.

Always steer clear of obstacles.

Do not hang heavy items on the handlebar.

Keep both feet on the deck all the time.

Always keep your hands on the handlebar.

Do not ride in traffic lanes or residential areas where vehicles and pedestrians are both allowed.

Do not turn the handlebar violently during high-speed riding.

Do not ride in a ponding that is higher than 1.5 inches.

No passengers are allowed, including children.

Keep your feet off the rear mudguard.

Do not try riding up or down stairs or jumping over obstacles.

As with any mechanical component, a vehicle is subject to high stresses and wear. The various materials and components may react differently to wear or fatigue. If the expected service life for a component has been exceeded, it may break suddenly, therefore risking causing injuries to the user. Cracks, scratches, and discoloration in the areas subject to high stresses indicate that the component has exceeded its service life and should be replaced.

When unboxing your i10 Pro electric scooter, the below items should be included in the package box:

• 1 x Scooter
• 1 x Charger
• 6 x Bolts (including 2 x Spare Bolts)
• 1 x Hex Wrench

To fold the ISCOOTER i10 Pro electric scooter:

1. Turn off the scooter.

2. Open the folding latch.

3. Fold down the stem until the folding clip on the handlebar catches the hook on the rear fender.

4. The stem can be used as a carrying handle and it’s ready to carry the scooter.

To unfold the ISCOOTER i10 Pro electric scooter:

1. Press the folding clip to release it from the hook.

2. Lift the stem up.

3. Close the folding latch until you hear a click.

If you see stains on the scooter’s body, wipe them off with a damp cloth. If the stains won’t scrub off, put on some toothpaste, and brush them with a toothbrush, then wipe them off with a damp cloth.

Notes for cleaning the ISCOOTER i10 Pro electric scooter:

Do not clean the scooter with alcohol, gasoline, kerosene or other corrosive and volatile chemical solvents to prevent dire damage.

Do not wash the board with a high-pressure water spray. During cleaning, make sure that the scooter’s turned off, the charging cable is unplugged, and the rubber flap is closed as water leakage may result in electric shock or other major problems. When the scooter not in use, keep it indoors where it is dry and cool.

Do not put it outdoors for a long time. Excessive sunlight, overheating and overcooling accelerate the battery pack’s lifespan.

Please try to store the ISCOOTER i10 Pro electric scooter in a cool and dry place between 14°F and 104°F. In extremely humid environments, the interior of the scooter may suffer condensation or even water accumulation, which may damage the battery rapidly.

Store indoors when not in use. Prolonged exposure to UV rays, rain, and the elements may damage the enclosure materials.

In daily use, try to avoid recharging the scooter after completely exhausting the battery. If the battery is low, charge it as soon as possible.

Please charge the scooter every other month to maximum the battery lifespan.

The specifications for the ISCOOTER i10 Pro Electric Scooter are:

If you see any error code listed below on the ISCOOTER i10 Pro display screen, please contact the iScooter support team to remove it:

Please take photos and send them to the iScooter support team by email. The iScooter support team will reply to you soon and send the correct accessory or replacement part.

Yes, the tires are replaceable. Please contact the iScooter support team or search “How to replace scooter tires” on YouTube.

Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.

Your ISCOOTER i10 Pro electric scooter will be fully charged when the charger indicator changes from red to green.

With charging protection, it will cut off charging automatically after fully charge. Even so, we still don’t recommend charging your scooter for a long time more than 24 hours at one time.

Use caution when using outlets to prevent electric shock.

Do not leave the charger plugged in for extended period of times (greater than 24 hours).

Only charge your scooter in a safe, clean, and dry environment. Keep the charger and scooter away from inflammable materials as they may get hot.

Only use the original battery packs and the original charger supplied with your scooter. Contact your place of purchase if you need a replacement. Use of other models or brands may not be safe.

Do not touch any part of the charging port and keep them away from metal objects to prevent short circuiting which may result in battery damage or physical injuries, and/or death.

Do not place the battery in direct contact with heat or near high temperatures.

Do not expose the battery to direct sunlight.

Do not leave the scooter in a car where the battery might get hot.

Do not pierce the battery with sharp objects. Do not subject it to impact or force.

Stop charging if the battery fails to recharge within the approximate charging time. This will prevent the battery from overheating, rupturing, or igniting.

Do not charge the battery in temperatures below 32°F or above 104°F as this can hamper performance, result in breaking, overheating, rupturing, or igniting and could cause personal injury or property damage.

Do not charge your scooter if the charging port on the scooter is damaged or wet. Do not charge if there is excessive heat, odor, or leakage coming from the battery or it looks abnormal in any way.

If the battery leaks and you accidentally get in touch with the liquid, rinse immediately and thoroughly with water and then seek medical care.

Never attempt to disassemble, modify, or perform repairs or maintenance on the battery. You run the risk of damaging the protective and safety components that prevent incidents, personal injury, or property damage.

Mishandling or misuse of the battery can result in lower performance, shorter lifespan, rupturing, igniting, or other incidents and could increase the risk of serious personal injury.

Do not discharge the battery using any other product than the scooter it comes with. Doing so could result in damage to other products or the battery and reduced lifespan of your scooter.

The battery could overheat, rupture, or ignite and cause personal injury or property damage.

In daily use, avoid recharging the scooter after completely exhausting the battery. If the battery level is low, charge the scooter as soon as possible.

Please charge the scooter every other month to preserve the battery.

Do not connect the charger if the charging port is wet.

Keep the charging port closed when not charging.

Do not dispose of your battery by way of land filling, incineration, or household trash.

We recommend disposing your battery through a local recycling program suitable for lithium-ion batteries. Contact your local waste management service for more information.

Mishandling of used batteries may do tremendous harm to the environment. You must abide by local laws and regulations to properly dispose of used batteries.

About the range: Measured under the condition of a full charge, a load of 154 lbs, at 75°F, on a flat road without wind, and at a speed of 9.3 mph. The actual range will differ depending on different factors, such as load, humidity, wind speed, and operation habits.

The maximum load capacity shall be kept within 264 lbs (including rider and belongings) in any case. Also consider the extra weight of the clothes and the gravity generated by speed.