ILVE ILFM775KX (01) PDF DOCUMENT

Please adhere to the following safety instructions when using your ILVE ILFM775KX cooktop:

THIS APPLIANCE IS CONCEIVED FOR DOMESTIC USE ONLY. THE MANUFACTURER SHALL NOT IN ANY WAY BE HELD RESPONSIBLE FOR WHATEVER INJURIES OR DAMAGES ARE CAUSED BY INCORRECT INSTALLATION OR BY UNSUITABLE, WRONG OR ABSURD USE.

THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN) WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE BY A PERSON RESPONSIBLE FOR THEIR SAFETY.

CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH THE APPLIANCE.

If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

WHERE THIS APPLIANCE IS INSTALLED IN MARINE CRAFT OR IN CARAVANS, IT SHALL NOT BE USED AS A SPACE HEATER.

DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION.

DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THIS APPLIANCE.

DO NOT MODIFY THIS APPLIANCE.

The ignition of the gas burner is carried out by putting a small flame to the upper part holes of the burner, pressing and rotating the corresponding knob in an anti-clockwise manner, until the maximum position has coincided with the marker. When the gas burner has been turned on, adjust the flame according to need. The minimum position is found at the end of the anticlockwise rotation direction.

For models with automatic ignition: Operate the knob as described above, pressing simultaneously, the corresponding push-button.

For models with automatic/simultaneous (with one hand) ignition: It is sufficient to proceed as described above using the corresponding knob. The electric spark between the ignition plug and the burner provides the ignition of the burner itself. After ignition, immediately release the push-button and adjust the flame according to need.

For models with a thermoelectric safety system: The burner is ignited as in the various cases described above, keeping the knob fully pressed on the maximum position for approximately 3/5 seconds. After releasing the knob, make sure the burner is actually lit.

Note: We recommend the use of pots and pans with a diameter matching that of the burner, thus preventing the flame from escaping from the bottom part and surrounding the pot. Do not leave any empty pots or pans on the fire. When cooking is finished, it is also a good norm to close the main gas pipe tap and/or cylinder.

To ensure efficient cooking and prevent flames from escaping around the pot, use the following recommended pot diameters for each burner type on your ILVE ILFM775KX:

Wok burner: Ø 20×32 cm

Fast (Rapid) burner: Ø 20-26 cm

Semifast (Semi-rapid) burner: Ø 14-20 cm

Auxiliary burner: Ø 10-14 cm

Ventilation: Use of the appliance produces heat and moisture in the room where it is installed. Make sure the kitchen is sufficiently ventilated; keep natural ventilation holes open or install mechanical ventilation devices (such as a hood).

Prolonged Use: Prolonged use of the appliance may require additional ventilation, such as opening a window.

Ignition with Thermoelectric Protection: Do not keep the ignite button pushed for more than 15 seconds. If the burner has not ignited after 15 seconds, open the door of the room and wait at least one minute before making a further attempt.

If Flame Goes Out (without protection): Should the burner flame go out, close the corresponding gas cock and wait at least one minute before making any attempt to ignite it.

Prior to any operation, disconnect the appliance from the electrical system. For a long life, a general cleaning operation must take place periodically, bearing in mind the following:

The glass and steel parts must be cleaned with suitable non-abrasive or corrosive products. Avoid chlorine-based products (bleach, etc.).

Avoid leaving acid or alkaline substances on the working area (vinegar, salt, lemon juice, etc.).

The wall and the small covers (mobile parts of the burner) must be washed frequently with boiling water and detergent, taking care to remove every possible encrustation. Dry carefully and check that none of the burner holes is fully or partially clogged.

Note: If the taps need to be lubricated, it must be performed by a qualified technician.

Check periodically the state of conservation of the flexible gas feed pipe. In case of leakage, call immediately the qualified technicians for its replacement.

DO NOT USE STEAM CLEANERS.

Any of the following are considered to be abnormal operation and may require servicing:

Yellow tipping of the hob burner flame.

Sooting up of cooking utensils.

Burners not igniting properly.

Burners failing to remain alight.

Burners extinguished by cupboard doors.

Gas valves, which are difficult to turn.

In case the appliance fails to operate correctly, contact the authorised service provider in your area.

Should the appliance be pre-set for a different type of gas than available, an authorised person must proceed as follows:

Replace the injector with the one corresponding to the type of gas to be used (see the “User characteristics” table).

To adjust the minimum flame, use a screwdriver on the screw placed on the tap after turning the tap to its minimum position. For Universal LPG, screw tight.

The Data Label is located on the bottom cover of the appliance. A duplicate Data Label is supplied to adhere in an accessible area next to the appliance. This appliance is suitable for Natural Gas and Universal LPG; ensure that the available gas supply matches the Data Label.