HEINNER HVC-MTB700YL (01) PDF Document

For the first operation, it is advisable to read the manual carefully and keep it for future use.

Before starting, make sure the dust cup is properly installed.

Ensure that your power supply is 220-240V 50Hz.

Do not vacuum water, inflammable materials, burning materials, or ashes.

Do not use the machine without the motor protection filter filled.

Change the dust cup or HEPA filter immediately if they are damaged.

Do not store or use the machine close to high temperature places.

Do not let children use the machine.

The plug must be removed from the power socket before any maintenance or replacement of parts is performed.

If abnormal noise, smell, smoke, or any other failure or breakage is found during operation, you should immediately turn off the switch and unplug the device. Do not attempt to repair the machine yourself; instead, contact a service center for repair.

The device consists of the following parts:

1. Lock clip

2. Front cover

3. Dust full indicator

4. Cord rewind pedal

5. Power cord

6. Back cover

7. ON/OFF switch pedal

8. Big wheel

The standard set of accessories includes:

Two pieces of plastic tube.

One floor brush.

One integrated brush.

To connect the hose accessories, insert the hose end into the hose socket located at the front cover and then hook it.

To remove the hose accessories, press the adaptors on both sides of the hose end and pull the hose accessories out.

Step 1. Connect the plastic tube to the curved end of the hose.

Step 2. Connect the appropriate nozzle tool to the tube for your specific cleaning purpose. Use the floor brush (adjusted to the ground type) for carpets or hard floors.

Step 3. Use the combined brush and nozzle for cleaning sofas, wall surfaces, curtains, corners, or spaces between furniture.

Step 1. Insert the cord plug into a power socket that conforms to the label specifications.

Step 2. Press the ON/OFF switch pedal to start the machine.

To rewind the cord, hold the plug and pull out the cord slightly, then press the cord rewinding pedal. The power cord will then be drawn into the interior of the appliance.

You should clear the dust or replace the bag when the wind indicator turns red.

Step 1. Open the front cover by clipping it.

Step 2. Take out the bag holder and then remove the full dust bag.

Step 1. Clip down and remove the outlet cover by hand.

Step 2. Replace the filter and reattach the cover.

The motor protection filter should be cleaned or exchanged once it is dirty. You should remove and rinse it once a year. It can be re-used only after it has completely dried. If the filter is damaged, it must be replaced with a new one.

Suction power may be reduced if:

The dust bag or dust cup is full. Empty the contents of the full container.

There is a blockage. If a blockage is found in the ground brush, hose, or tubes, the machine can only be re-operated after the blockage is cleared away.

To help protect the environment, respect local regulations by handing in non-working electrical equipment to an appropriate waste disposal center for environment-friendly disposal.