HANSEATIC HFD18983DWDBI (01) PDF Document

The HANSEATIC HFD18983DWDBI is designed to refrigerate fresh food, store commercially available deep-frozen food, deep-freeze fresh, room-temperature food, make ice cubes, and draw cold drinking water.

The HANSEATIC HFD18983DWDBI is designed for use at ambient temperatures between +10 °C and +43 °C.

If the supply cord of the HANSEATIC HFD18983DWDBI is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons to avoid a hazard.

To remove the odour present in new appliances like the HANSEATIC HFD18983DWDBI, wipe down the interior with a solution made of 100 ml of vinegar and 200 ml of water. Afterward, wipe it with clean water and dry all parts thoroughly.

The HANSEATIC HFD18983DWDBI is switched on as soon as you plug the mains plug into the socket.

If no sensor buttons are touched for 30 seconds, all lights on the display of the HANSEATIC HFD18983DWDBI will go out. To turn the indicators back on, touch any sensor button or open an appliance door.

1. To change the refrigerator temperature on the HANSEATIC HFD18983DWDBI, press the sensor button TEMP. SELECT.

2. Adjust the temperature using the sensor buttons for up or down. Each press lowers or raises the set temperature by 1 °C. The setting takes effect once the display panel is locked. The setting range is +2 °C to +8 °C.

1. To change the freezer temperature on the HANSEATIC HFD18983DWDBI, press the button TEMP. SELECT.

2. Adjust the temperature using the sensor buttons for up or down. Each press lowers or raises the set temperature by 1 °C. The setting takes effect once the display panel is locked. The setting range is -24 °C to -16 °C.

To activate Super Cooling mode on the HANSEATIC HFD18983DWDBI, after the refrigerator temperature is set to 2 °C, press the down sensor button. The refrigerator temperature is automatically set to 2 °C. It is automatically deactivated after 6 hours.

To activate Super Freeze mode on the HANSEATIC HFD18983DWDBI, after the freezer temperature is set to -24 °C, press the down sensor button. The freezer temperature is automatically set to -24 °C. It is automatically deactivated after 24 hours.

To set the Flex zone on the HANSEATIC HFD18983DWDBI, press the sensor button VARIO TEMP. The options are: Keep cool (for a small amount of meat stored for 1-2 days), Beverage (for dry goods and drinks), and Fruit (for fruits and vegetables).

To lock or unlock the HANSEATIC HFD18983DWDBI control panel, press and hold the LOCK/UNLOCK sensor button for 3 seconds.

1. Push up the closure cap of the water tank on the HANSEATIC HFD18983DWDBI.

2. Pour up to 2.2 litres of fresh tap water into the tank and close the cap.

Press the water vessel against the dispenser pad of the water dispenser on the HANSEATIC HFD18983DWDBI. Cold water will begin to flow.

The HANSEATIC HFD18983DWDBI has a door alarm that sounds if one or both doors have been open for more than 2 minutes.

To remove a door shelf from the HANSEATIC HFD18983DWDBI, gently press in the sides and pull the shelf up.

The glass shelves in the HANSEATIC HFD18983DWDBI have a removal lock. To remove one, pull it out slightly and then lift it upwards.

To remove a refrigerator drawer from the HANSEATIC HFD18983DWDBI, hold the handle and pull it out completely as far as it will go.

1. Pull out the upper or lower freezer drawer of the HANSEATIC HFD18983DWDBI.

2. Press the levers on both sides simultaneously.

3. Pull the drawer out completely.

Storage guidelines for the HANSEATIC HFD18983DWDBI include: Top door shelves for cheese and butter; middle door shelves for jars, small bottles, tubes, and eggs; bottom door shelves for drinks cartons and bottles; glass shelf above large vegetable drawer for fresh meat, game, and fish; and the small vegetable drawer for broccoli, carrots, and spinach.

1. Remove the ice cube maker from the HANSEATIC HFD18983DWDBI ice cube collecting container.

2. Fill the filling container to the 55 ml mark for each ice tray.

3. Pour the water into the trays through the lid’s funnel-shaped openings.

4. Place it back in the freezer.

1. Remove the ice cube maker from the HANSEATIC HFD18983DWDBI freezer drawer.

2. Push the ice cube maker ejector down firmly in the direction of the arrow to rotate the trays and drop the cubes into the container.

3. Use the included scoop to retrieve the ice cubes.

To check the seals of the HANSEATIC HFD18983DWDBI, clamp a thin piece of paper between the seal and the frame. The paper should be difficult to pull through at all points.

Use only light, pH-neutral soapy water to clean the exterior of the HANSEATIC HFD18983DWDBI.

Carefully brush the back of the HANSEATIC HFD18983DWDBI and the compressor with a soft brush once or twice a year to remove dust.

1. Unplug the HANSEATIC HFD18983DWDBI.

2. Remove shelves and drawers.

3. Clean parts in lukewarm soapy water and dry thoroughly.

4. Wipe the interior with water containing a little vinegar to prevent mould.

The water tank of the HANSEATIC HFD18983DWDBI can be disassembled by removing the outlet valve and brackets. Wash the individual parts with warm, soapy water, rinse well with clean water, and reassemble carefully, ensuring the seal is correctly positioned.

The HANSEATIC HFD18983DWDBI uses maintenance-free LEDs. Do not attempt to replace the light yourself; if it fails, please contact support.

The HANSEATIC HFD18983DWDBI climate category is SN-N-ST-T, which means it is intended for operation at ambient temperatures between +10 °C and +43 °C.

The dimensions of the HANSEATIC HFD18983DWDBI are 1898 mm x 833 mm x 653 mm (Height x Width x Depth).

If the compressor of the HANSEATIC HFD18983DWDBI is off, first check if the socket has electricity and ensure the mains plug is inserted firmly. If the interior light is also on, the target temperature may have already been reached.

Some noises from the HANSEATIC HFD18983DWDBI are normal, such as humming when the unit runs, flowing sounds from refrigerant, or clicking when the compressor switches on/off. If the noise is disturbing, check the stability of the unit and ensure no foreign objects are behind it.

Check if food packaging is blocking the doors of your HANSEATIC HFD18983DWDBI or if too much food has been placed inside. Also, ensure the appliance is level.

The HANSEATIC HFD18983DWDBI error codes are: E1 (fridge sensor error), E2 (freezer sensor error), E3 (Flex zone sensor error), E5 (freezer defrost sensor error), E6 (communication error), E7 (temperature circulation sensor error), and EH (moisture sensor error).

The HANSEATIC HFD18983DWDBI uses R600a refrigerant.

Raise the bottom appliance door to the level of the top door of the HANSEATIC HFD18983DWDBI, then insert the supplied fixing ring into the gap between the hinge rubber and the lower hinge using pliers.

No, the HANSEATIC HFD18983DWDBI must be connected directly to a properly installed earthed electric socket. Do not use multi-socket extensions or multi-socket plugs.

If the HANSEATIC HFD18983DWDBI was transported horizontally, let it stand upright for 2 hours before switching it on.

The HANSEATIC HFD18983DWDBI has a rated power of 280 W.

No, the HANSEATIC HFD18983DWDBI is not designed for use as a built-in appliance.

No, the HANSEATIC HFD18983DWDBI is not suitable for storing medical products, blood reserves, or laboratory samples.

To defrost the HANSEATIC HFD18983DWDBI, remove frozen food and store in a cool place, place a bowl of hot (not boiling) water inside the freezer, and wipe the interior clean once all ice has melted.

The unloaded weight of the HANSEATIC HFD18983DWDBI is 130 kg.

No, the HANSEATIC HFD18983DWDBI must only be used indoors and not in wet rooms or in the rain.

Yes, do not use harsh, granular, soda, acid, solvent-based, or abrasive cleaners on the HANSEATIC HFD18983DWDBI as these will damage the plastic surfaces.

The water tank of the HANSEATIC HFD18983DWDBI has a maximum capacity of 2.2 litres.

No, the HANSEATIC HFD18983DWDBI is not intended to be operated by means of an external timer or a separate remote control system.

The HANSEATIC HFD18983DWDBI corresponds to protection class I.

The recommended storage period for fresh meat in the fridge compartment of the HANSEATIC HFD18983DWDBI should not exceed 24 hours.

Level the HANSEATIC HFD18983DWDBI by turning the adjustable front feet. Tilt the appliance slightly backwards, and screw the feet until the unit is upright, secure, and does not wobble.

Before cleaning the HANSEATIC HFD18983DWDBI, always pull the mains plug out of the socket or unscrew/isolate the fuse.

When unpacking the HANSEATIC HFD18983DWDBI, do not use sharp or pointed objects and ensure you do not damage the insulation material on the back of the appliance.

In the HANSEATIC HFD18983DWDBI, store raw meat and fish in suitable containers so that it is not in contact with or drips onto other food.

Yes, maintain 100 mm from electric stoves, 300 mm from oil/coal stoves, 100 mm from other cooling appliances, and 100 mm from washing/dishwashing machines for the HANSEATIC HFD18983DWDBI.

No, never use defrosting sprays on the HANSEATIC HFD18983DWDBI; they can generate explosive gases.

The HANSEATIC HFD18983DWDBI uses cyclopentane as a foaming agent.

Yes, the HANSEATIC HFD18983DWDBI contains a light source of energy efficiency class G.

The HANSEATIC HFD18983DWDBI requires a supply voltage of 220-240 V and a frequency of 50 Hz.

Yes, store high-percentage alcohol in the HANSEATIC HFD18983DWDBI only standing upright and tightly closed.

The interior walls and frozen food in the HANSEATIC HFD18983DWDBI have very low temperatures. Never touch them with wet hands to avoid skin injury.

The HANSEATIC HFD18983DWDBI can be used by children aged 8 and above and persons with reduced physical or mental abilities if supervised or instructed on safe use.

Yes, children from 3 to 8 years are allowed to load and unload the HANSEATIC HFD18983DWDBI.