Free English GEMBIRD EE2280-U3C-01 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD GEMBIRD EE2280-U3C-01 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the key features of the GEMBIRD EE2280-U3C-01 M.2 drive enclosure?
The GEMBIRD EE2280-U3C-01 offers the following features:
SuperSpeed SSD access via a USB 3.0 Micro-B connection.
Backward compatibility with USB 2.0 interfaces.
Support for M.2 (NGFF) drives of any storage capacity.
What are the technical specifications for the GEMBIRD EE2280-U3C-01?
The specifications for the GEMBIRD EE2280-U3C-01 are detailed in the following table:
| Input Port | USB Micro-B female (supports USB 3.0, compatible with USB 2.0) |
| Drive Support | M.2 drives with 22 mm width (2230, 2242, 2260, 2280) |
| Chipset | JMS578 or AMS225 |
| Material | Aluminum |
| Product Net Weight | 38 g |
| Product Dimensions | 102 x 37 x 10 mm |
Which M.2 drive sizes are compatible with the GEMBIRD EE2280-U3C-01?
The GEMBIRD EE2280-U3C-01 supports M.2 drives that are 22 mm wide, specifically in the following lengths:
2230
2242
2260
2280
How do I install an M.2 drive into the GEMBIRD EE2280-U3C-01 enclosure?
To install a drive into your GEMBIRD EE2280-U3C-01, follow these steps:
Step 1: Use a screwdriver to remove the two screws securing the end cap of the enclosure and remove the cap.
Step 2: Slide the internal PCB out of the aluminum housing. Insert your M.2 drive into the slot on the PCB at an angle and then lay it flat. Use a screwdriver to secure the drive to the PCB using the screw hole that corresponds to your drive’s length (2242, 2260, or 2280).
Step 3: Slide the PCB back into the aluminum housing, replace the end cap, and secure it by re-installing the two screws.
How do I connect the GEMBIRD EE2280-U3C-01 to a computer?
Once the drive is installed in the GEMBIRD EE2280-U3C-01, connect the included USB cable to the USB Micro-B port on the enclosure. Plug the other end of the USB cable into an available USB port on your laptop or computer to begin accessing your data.
CLICK HERE TO DOWNLOAD GEMBIRD EE2280-U3C-01 (01) PDF DOCUMENT