GE 72152LO (01) PDF Document

When using the GE 72152LO, you should follow these basic precautions:

A) When used in outdoor applications, connect the product to a Ground Fault Circuit Interrupting (GFCI) outlet. If one is not provided, contact a qualified electrician for proper installation.

B) This seasonal use product is not intended for permanent installation or use.

C) Do not mount or place near gas or electric heaters, fireplaces, candles or other similar sources of heat.

D) Do not plug-in the power adapter when the product is in the packaging.

E) Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.

F) Do not let lamps rest on the supply cord or on any wire.

G) Unplug the product when leaving the house, when retiring for the night, or if left unattended.

H) This is an electric product-not a toy! To avoid risk of fire, burns, personal injury and electric shock it should not be played with or placed where small children can reach it.

I) Do not use this product for other than its intended use.

J) Do not hang ornaments or other objects from cord, wire, or light string.

K) Do not close doors or windows on the product or extension cords as this may damage the wire insulation.

L) Do not cover the product with cloth, paper or any material not part of the product when in use.

M) Do not install or use within 10 feet of a pool.

N) Do not use in a bathroom.

O) Read and follow all instructions that are on the product or provided with the product.

A) This is not a toy, keep away from children.

B) If the supply cord or wires are damaged, the product should be discarded.

C) Risk of Electric Shock. When used outdoors, install only to a covered class A GFCI protected receptacle that is weatherproof with the power unit connected to the receptacle. If one is not provided, contact a qualified electrician for proper installation. Ensure that the power unit and cord do not interfere with completely closing the receptacle cover.

D) Risk of Fire. Installation involves special wiring methods to run wiring through a building structure. Consult a qualified electrician.

E) When used outdoors, install only to a Class A GFCI protected receptacle where the transformer is protected from water or rain while plugged in (completely covered by the outlet box while plugged in). Do not use where only part of the transformer is protected from rain or water (outlet boxes where there is only a partial cover shall not be used for outdoor installations). This power unit is intended to be correctly orientated in a vertical or floor mount position.

If the ball does not light when plugged in, check to ensure all light string connections are secured.

The transformer has a built-in fuse which automatically cuts power to the transformer if it short circuits due to unstable input power, overloaded output, and other reasons. This fuse is a one shot device and cannot be reset; please replace the transformer if it activates.

1. Use only the class 2 power supply, model: TS-5V2A, manufactured by TING SHEN INDUSTRIAL CO LTD that was provided with this product. Do not use this adapter with any other product.

2. The LEDs in this set are non-replaceable. Tampering with this set will void the warranty.

1. This product can be installed in either indoor or outdoor locations, but avoid splashing water from falling onto, or reaching the transformer.

2. General information:

2.1 Damage may occur to this product if used in extreme temperatures.

2.2 Do not change the wiring on the end product.

2.3 Please use correct voltage for your product by checking the nameplate information on the transformer.

3. After finishing the installation, please plug into a 120VAC/60Hz electrical outlet.

This lighting string is rated 19.2 Watts (0.16Amps). Do not overload.

1) Before using or reusing, inspect product carefully. Discard any products that have cut, damaged, or frayed wire insulation or cords; cracks in the lamp holders or enclosures, loose connections, or exposed copper wire.

2) When storing the product, carefully remove the product from wherever it is placed, to avoid any undue strain or stress on the product conductors, connections, and wires.

3) When not in use, store neatly in a cool, dry location protected from sunlight.

4) To reduce the risk of fire or electric shock, do not attempt to replace lamp or modify string.

5) Use 2pcs AAA battery for remote controller.

6) Non-rechargeable batteries are not to be recharged.

7) Batteries are to be inserted with the correct polarity.

8) Exhausted batteries are to be removed from the product.

9) DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY EXPLODE OR LEAK.

10) Caution for ingestion (small batteries only).

11) Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.

12) Do not mix old and new batteries.

When using the remote control, please point it to the control box. The Power On/Off functions and lighting modes can be controlled with either the remote control or the control box.

Pressing the Timer button (C) will activate the lighting timer for 5 hours. At the end of 5 hours, the lights will automatically turn OFF. The product will turn ON automatically the next evening at the same time. Using the remote control On/Off Power switch will cancel the Timer. The timer function cannot be activated using the Control Box button switch.

The letters A to I (Except for the C key) on the remote correspond to the 8 function keys. For example, press the key A to select the function of A switch in the list (Fade Combo). For functions with multiple options, like button B, press the key B repeatedly to cycle through the functions 1-3 of the B switch in the list (functions White Twinkle, Multi Twinkle, and Twinkle).

The Timer function cannot be activated using the Control Box button switch. The function sequence for pressing the Control Box button is as follows: key A, 1-3 of key B, 1-3 of the key D, 1-2 of the key E, 1-9 of the key F, 1-3 of the key G, 1-2 of the key H, key I, and ON/OFF function.