Free English FORD M-7195-4R (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD FORD M-7195-4R (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What parts are included in the FORD M-7195-4R kit?
| Quantity | Part Name |
|---|---|
| 1 | Deep cast aluminum oil pan |
| 1 | Drain plug |
| 1 | Drain plug washer |
| 14 | Socket head cap screws M8 x 25mm |
| 14 | Lock washers |
How should I prepare the vehicle before installing the FORD M-7195-4R?
STEP 1: Raise and properly support your vehicle with jack stands. See your owners’ manual for correct jacking points.
How do I remove the old transmission pan and drain the fluid for the FORD M-7195-4R installation?
STEP 2: Place drain pan under transmission oil pan. Loosen all pan attaching bolts to within a few turns of removal. Carefully break the gasket seal allowing the fluid to drain.
STEP 3: When most of the fluid has drained, remove the pan and allow the balance of the fluid to drain into the drain pan.
How should the transmission flange surface be cleaned before installing the FORD M-7195-4R?
STEP 4: Clean transmission flange surface with safe solvent. Allow drying time.
What is the installation procedure and torque specification for the FORD M-7195-4R?
STEP 5: Place new gasket on cast pan, then install pan with supplied hardware and torque to 120 in-lb.
How much transmission fluid should be added after installing the FORD M-7195-4R?
STEP 6: Add three quarts of recommended transmission fluid; see owners’ manual. Additional fluid will be required after starting vehicle.
What steps should be taken to finalize the FORD M-7195-4R installation after adding fluid?
STEP 7: Lower vehicle.
STEP 8: Start engine and move gear selector through the shift pattern.
STEP 9: Check fluid level per owners’ manual.
CLICK HERE TO DOWNLOAD FORD M-7195-4R (01) PDF DOCUMENT