Free English FORD M-6200-A514 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD FORD M-6200-A514 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What constitute the FORD M-6200-A514 connecting rods?
The FORD M-6200-A514 connecting rods are reconfigured heavy-duty marine/truck production 460 stock length (6.605″) rods that have been bushed for a .990″ floating pin and fitted with ARP 190,000 psi Waveloc bolts.
What are the recommended applications and RPM limits for the FORD M-6200-A514?
These rods are adequate for drag racing and similar applications (i.e. short duration runs). However, even after polishing and shotpeening, the rods are not recommended for extended operation at high RPM (over 6000).
How can the durability of the FORD M-6200-A514 connecting rods be improved?
The durability can be improved by polishing and shotpeening which is highly recommended. This work should be done by a qualified race engine shop.
What preparation steps are required regarding the weight of the FORD M-6200-A514 rods before assembly?
The rods have been weight matched but they should be rechecked before assembly. Trim the weight pads as required to correct any variations. Additionally, inspect for any material flaws before using.
How many pin locks are required for assembling the FORD M-6200-A514 rods?
Two pin locks per side are required to assemble the rods and M-6108-B514 pistons (included with the pistons).
What is the torque specification for the bolts on the FORD M-6200-A514?
Torque the rod bolts to 50 ft./lbs. using 30 wt. engine oil.
What is the seating procedure for the rod bolts on the FORD M-6200-A514?
On initial assembly, back off and retorque the rod bolts two times to “seat” the nuts.
What are the clearance specifications and orientation instructions for the FORD M-6200-A514?
Rod side clearance should be .010″ – .015″ per pair with chamfers facing the crank journal filet.
CLICK HERE TO DOWNLOAD FORD M-6200-A514 (01) PDF DOCUMENT