FELLOWES POWERSHRED 450MS (01) PDF MANUAL


Post questions, comments, reviews or page errors in the comment box below.

Click here to download FELLOWES POWERSHRED 450MS (01) PDF MANUAL


PDF Content Summary:

****** Page 1 ****** POWERSHRED 450Ms Fellowes HE WORLD’S TOUGHEST SHREDDERS Fellowes. Please read these instructions before use. Do not discard: keep for future reference. Fellowes Quality Office Products Since 1 91 7

****** Page 2 ****** ENGLISH Model B. c. D. E. G. CAPABILITIES Will shred: Paper, credit cards, CD/DVDs and staples KEY A. SafeSense@Technology B. CD/card entry C. See safety instructions D. Paper entry E. Pull-out bin F. Window G. Casters H. ON/OFF switch O l. OFF l. Control Panel and LEDs l. Overheat (red) 2.SafeSense@indicator (yellow) 3. ON/OFF (blue) 4. Reverse > 5. Forward Will not shred: Adhesive labels, continous form paper, transparencies, newspaper, cardboard, laminates, paper clips, file folders, X-rays or plastic other than noted above Paper shred size: Micro-Cut 5/64 in. x 5/16 in. (2mm x 8mm) Card/CD shred size: 5/16 in. (8mm) Strip-Cut Maximum: Sheets per pass Cards/CDs per pass Paper entry width 8-13/16 in. (224mm) Cards/CDs width 4-7/8 in. (124mm) *8.5 in. XII in., 201b., (75g) paper at 120V, 60 Hz, 4.5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Maximum recommended daily usage rates: 300 sheets per day; 25 credit cards; 10 CDs. 7 sheets per pass to avoid jams. Fellowes SafeSense@shredders are designed to be operated in home and office environments ranging between 50 — 80 degrees Fahrenheit (10 — 26 degrees (elsius) and 40 — 80% relative humidity. AWARNING: IMPORTANT SAFETY INSTRUCTIONS – Read Before Using! Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders. Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use. Keep foreign objects — gloves, jewelry, clothing, hair, etc. — away from shredder openings. If object enters top opening, switch to Reverse (KK) to bock out object. Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder. Do not use if damaged or defective. Do not disassemble shredder. Do not place near or over heat source or water. This shredder has an ON/OFF Switch (H) that must be in the ON (l) position to operate shredder. In case of emergency, move switch to OFF (0) position. This action will stop shredder immediately. Avoid touching exposed cutting blades Under shredder head. Shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product. FIRE HAZARD Do NOT shred greeting cards with sound chips or batteries. For indoor use only. Unplug shredder before cleaning or servicing.

****** Page 3 ****** BASIC SHREDDING OPERATION Continuous operation: Up to 8-minutes maximum NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 8-minutes will trigger 20-minute cool down period. PAPER OR CD CARD Plug in and turn ON (l) Feed paper straight into paper entry and release Hold (D/card at edge, feed right side of entry and release When finished shredcfing set to OFF (0) ADVANCED PRODUCT FEATURES SAFE SENSE TECHNOLOGY Patented SafeSense@Technology Stops shredding immediately when hands touch the poper opening. SilentShredTM Technology SilentShredTM noise quality shreds without noisy disruptions. SAFE SAFESENSE@ TECHNOLOGY SENSE Stops shredding immediately when hands touch the paper opening. TECHNOLOGY Turn the shredder ON (l) to activate SafeSense@ Touch test area and look for the SdfeSense@ indicator to illuminate SafeSense@is active and working properly For more information about all of Fellowes Advanced Product Features go to fellowes.com PRODUCT MAINTENANCE OILING SHREDDER All micro-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding, and could Ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin. FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE *Apply oil across entry Press and hold forward 2-3 seconds *Only use a non-aerosol vegetable ON in long nozzle container such as Fellowes 35250 CLEANING AUTO-START INFRARED SENSORS Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run even if there is no paper present. (Note: two paper detection sensors are located in the center of the entry). OFF (0) and unplug shredder Locate Auto-start infared sensor Dip cotton swab in rubbing alcohol Using cotton swab, wipe owoy any contamination from the paper sensors Go to Support Section at fellowes.com or see back page of manual for useful telephone numbers. TROUBLESHOOTING SAF SENSE Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder. SafeSense@ Indicator: If hands are too close to the paper entry, the SafeSense@ indicator will illuminate and the shredder will stop shredding.

****** Page 4 ****** Fellowes LIMITED PRODUCT WARRANTY POWERSHRED 450Ms THE WORLD’S TOUGHEST SHREDDERS Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for I year from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer. Questions or Concerns? fellowes.com Troubleshooting Registration Manuals Canada Mexico United States Fellowes Custotper Service & Support Troubleshooting Replacement parts General questions +1-800-665-4339 +001- 800-514-9057 +1-800-955-0959 1789 Norwood Avenue, Itasca, Illinois 60143-1095 • USA• 630-893-1600 02012 Fellowes, Inc. Part No. 407314 Rev B fellowes.com


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE – USER MANUAL

OWNER GUIDE – OWNER MANUAL

REFERENCE GUIDE – REFERENCE MANUAL

INSTRUCTION GUIDE – INSTRUCTION MANUAL

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.