ERGOLUX ELDSKRPLWOA (01) PDF DOCUMENT

Please adhere to the following safety guidelines when using your ERGOLUX ELDSKRPLWOA desk riser:

• Read and follow the assembly instructions carefully. Improper installation may result in damage or serious personal injury.

• Retain the user guide for future reference.

• Safety gear and proper tools must be used during assembly.

• Ensure that the supporting surface can safely support the combined weight of the equipment and all attached hardware and components.

• Use the provided mounting screws and DO NOT OVER TIGHTEN them.

• This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.

• This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.

• **Important:** Before installation, ensure you have received all parts according to the component checklist. If any parts are missing or faulty, contact your place of purchase for a replacement.

To prevent instability and possible injury, do not exceed the rated weight limits for the ERGOLUX ELDSKRPLWOA:

• **Desktop:** 15kg (33lbs)

• **Keyboard Tray:** 2kg (4.4lbs)

Check that the ERGOLUX ELDSKRPLWOA is secure and safe to use at regular intervals, at least every three months.

The following components are included with your ERGOLUX ELDSKRPLWOA:

• A (x1) – Main Desk Assembly

• B (x1) – Keyboard Tray

• C (x4) – Keyboard Tray Fasteners

• D (x2) – Cable Clips

• E (x3) – Protective Pads

• F (x4) – Protective Feet

Follow these steps to assemble your ERGOLUX ELDSKRPLWOA:

Step 1: Prepare the Fasteners

Separate the keyboard tray fastener (C) into its two parts, C1 and C2.

Step 2: Prepare the Keyboard Tray

Insert the C1 parts of the fasteners into the pre-drilled holes on the keyboard tray (B). Then, apply the adhesive protective pads (E) onto the designated spots on the top surface of the keyboard tray.

Step 3: Prepare the Main Desk Assembly

Place the main desk assembly (A) upside down on a flat surface. Attach the protective feet (F) to the base. Carefully cut the plastic strip lock with scissors. WARNING: Do not press the release handle while cutting off the plastic strip lock. Only press the release handle when the desk is in an upright position.

Step 4: Adjust the Desk Height

Turn the desk assembly upright. You can now adjust the height by squeezing the release handle.

Step 5: Attach the Keyboard Tray

Align the keyboard tray (B) with the brackets on the main desk assembly. Hook the tray onto the brackets and then secure it from underneath using the C2 parts of the fasteners with a screwdriver.

Step 6: Cable Management

Use the adhesive cable clips (D) to organize and manage your cables along the frame of the desk riser.

Step 7a: Optional Monitor Arm Installation

1. Remove the grommet cap from the hole in the desktop.

2. Insert your compatible monitor mount through the grommet hole.

3. Secure the monitor mount from underneath the desk surface according to its instructions.

Step 7b: Standard Monitor Placement

If not using a monitor arm, you can place your monitor directly on the desktop surface.