ENFORCER EV-6681-N3WQ (01) PDF MANUAL

ENFORCER EV-6681-N3WQ (01) PDF SUMMARY:

Before Starting?

1. Please read this manual carefully and keep it for future reference.
2. Use the camera within given temperature and electrical limits.
3. Do not mount the camera where it is exposed to rain or other moisture, or in humid or dusty places.
4. Do not point the camera at the sun. Heat could damage the camera, even when not in use.
5. Do not mount the camera in areas exposed to radiation, strong magnetic fields, or strong electrical signals.
6. Do not open or disassemble the camera. There are no user-serviceable parts inside.
7. Do not drop the camera or subject it to strong vibrations.
8. For OSD programming, see separate OSD programming manual.

How do I install the camera?

1. Run a 12VDC power supply wire and a video cable with a male BNC connector through the wall to where the camera will be mounted.
2. Connect the camera’s video and power cables.
3. Temporarily mount the camera to test its function and display.
4. Do a preliminary test of the camera to ensure it will work properly.
5. Program the camera if needed via the attached OSD joystick. For OSD programming, see separate OSD programming manual.
6. EV-6680 Series Only: The motion-activated LED is tied to the motion detection feature in the OSD. To turn this feature ON or OFF, see page 9 of the OSD manual.
7. Partially screw a screw into the wall where the top of the bracket should go. Slide the bracket onto the screw. Finish securing the top of the bracket to the wall.
8. Secure the bottom of the bracket to the wall.
9. Attach the mounting bracket ball to the mounting bracket by gently pushing the ball into the bracket.
10. Attach the camera to the assembled bracket by sliding the camera downward.
11. Do a final test of the video camera and monitor.

What should I do if the screen is blank?

• Check that the camera is powered up.
• Check that the power supply’s polarity is correct.
• Check that the monitor is powered up.
• Check that the video cable connecting the camera to the monitor is connected properly.

What should I do if the screen image is dim?

• Clean the lens using a soft, clean cloth.
• Check that the light source is adequate.
• Check that the IR LEDs turn on when light is low (EV-6681-N3WQ and EV-6681-P3WQ only)

What should I do if the screen image has poor contrast?

• Adjust the monitor’s contrast knob.
• Change the position of the camera.

What should I do if the screen image flickers?

• Change the position of the camera.

What should I do if the screen image is distorted?

• Change the position of the camera.

What should I do if the camera case is hot?

• Check that the correct power supply is in use.

What warnings are there about using this camera?

Stop using the camera if you see a malfunction such as smoke or unusual heat, as it could cause fire or electric shock. Do not open the case of this device, as there are no user-serviceable components inside. Users and installers of this product are responsible for ensuring this product complies with all national, state, and local laws and statues related to monitoring and recording audio and video signals. SECO-LARM will not be held responsible for the use of the product in violation of any current laws or statutes.