ELVIE CATCH EA01 (01) PDF MANUAL

Take Elvie Catch apart before cleaning or sterilizing.

Sterilizing (before first use and subsequently once a day):

Sterilize parts in boiling water for five minutes.

OR Suitable for microwave, steam or cold water sterilizing methods.

Cleaning (after every use):

Wash with clean, soapy water. Rinse thoroughly.

OR Place on the top shelf of the dishwasher.

Elvie Catch should be stored clean, dry and fully assembled.

1. Push the Cup into the groove on the Skirt. Make sure it is pushed into place all the way around.

2. Place your Elvie Catch into your bra, so it’s securely held in place. For the best comfort and fit, we recommend wearing Elvie Catch with a nursing bra.

3. Center your nipple in the Nipple Hole.

4. Be sure to check your milk level regularly, to make sure it doesn’t overfill. Do not allow the milk level to go above the bottom of the Nipple Hole.

5. We recommend removing Elvie Catch every two to three hours, to allow the nipple to completely air-dry. When removing, it may help to lean forwards slightly.

6. Elvie Catch is not designed to store milk. Pour milk through the top of the Nipple Hole as shown in the illustration.

Please note: Milk collected over extended periods and left at room temperature for too long should not be fed to your baby.

‘Elvie Catch’ is to be used by lactating women to collect leaking milk during and between breastfeeding, when there is unintentional milk flow from the breast.

Skirt: Silicone, Cup: Polypropylene

• Inspect for damage prior to first use and after every use.

• Do not store wet or damp parts, as mold may develop.

• Do not drop or insert any foreign object into any openings of the device.

• If the package appears damaged or tampered with before use, do not use.

• Keep Elvie Catch away from excessive heat and open flame.

• Do not wear Elvie Catch for more than three hours.

• Only use Elvie Catch for its intended use as described in this manual.