ELICA EVR636S2 (01) PDF MANUAL

To reduce the risk of injury in the event of a range top grease fire, observe the following:

a) SMOTHER FLAMES with a close-fitting lid, cookie sheet, or other metal tray, then turn off the gas burner or the electric element. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.

b) NEVER PICK UP A FLAMING PAN – you may be burned.

c) DO NOT USE WATER, including wet dishcloths or towels – a violent steam explosion will result.

d) Use an extinguisher ONLY if:

1) You know you have a class ABC extinguisher, and you already know how to operate it.

2) The fire is small and contained in the area where it started.

3) The fire department is being called.

4) You can fight the fire with your back to an exit.

e) Ducted fans must always be vented to the outdoor.

^aBased on “Kitchen Fire Safety Tips” published by NFPA.

FOR GENERAL VENTILATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VAPOURS.

To reduce the risk of fire or electric shock, do not use this hood with any external solid state speed control device.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Models
EVR630S2 EVR630BL	EVR636S2 EVR636BL
A	30″ (76.2 cm)	36″ (91.4 cm)
B	19 11/16″ (50 cm)
C*	Max: 42 1/8″ (107 cm) Min: 28 5/16″ (72 cm)
D**	Max: 38 3/16″ (97 cm) Min: 28 5/16″ (72 cm)
E	6″ (15.24 cm)
F	7 3/16″ (18.3 cm)
G	8 3/16″ (20.8 cm)

* Ductless (Recirculating) version

** Ducted version

KIT	# Part
Recirculating Kit	KITO2766
Long Chimney Extension	KITO2762
Long Chimney Extension Black	KIT0140998

Installation Heights
GAS cooktops	30″ (76.2 cm)
ELECTRIC cooktops	27″ (66.6 cm)

There is no maximum mounting height, however, we recommend mounting the hood no greater than 36″ (91.4 cm) above the cooking surface. For every inch (2.54 cm) above 36″ (91.4 cm), fume and moisture capture efficiency diminishes at an increasing rate and may not deliver an acceptable level of ventilating performance.

This hood is intended for household use.

PLEASE READ THE INSTALLATION MANUAL FOR SPECIFIC APPLICATION. Check your ceiling height and hood height before selecting your hood.

1. Blower and light controls

2. LED lamps

3. Grease filter handle

4. Grease filter

5. Duct covers

1. Button ON/OFF motor (stand by)

2. Button for low speed (suction power) selection. When flashing, it indicates that you must wash the grease filter.

3. Button for medium speed (suction power) selection

4. Button for high speed (suction power) selection

5. Button for intensive speed (suction power) selection. It lasts 5 minutes then it returns to medium speed (suction power).

6. Button ON/OFF lighting. Press briefly to switch on or off the lighting of the hood. Press and hold to adjust the intensity of the light.

At regular time intervals, the hood indicates the need of performing filter maintenance.

Button MAX on with steady light: Perform grease filter maintenance.

Button MAX flashing: Perform activated charcoal filter maintenance.

NOTE: Filter saturation signal is visible within the first minute after switching off the hood; within this time, the reset of saturation indicators must be performed.

Press and hold the button MAX.

NOTE: This operation must be performed with the hood off. This indicator is normally deactivated.

To activate: press and hold the MAX button to activate the function: the button lights up with steady light.

To deactivate: press and hold the MAX button: the button lights up flashing.

Some States and Provinces of the US & Canada restrict the maximum exhausting airflow of range hoods. If your local code mandates a maximum airflow level below the maximum airflow of this hood (i.e. 600 CFM), please execute the procedure below to reduce the maximum airflow.

1. Turn the motor OFF.

2. Press the ON/OFF (1) and Intensive speed (5) buttons together for 3 seconds.

3. You will hear a beep and all control lights will illuminate for 3 seconds. This action will Disable speeds 3 and 4 and effectively lower the Maximum airflow to > 300 CFM.

4. Locate the CFM certification sticker in the hardware pack. Peel and Affix this sticker to a visible area in the blower. This sticker provides official certification to your local inspector that this hoods maximum airflow has been reduced to > 300 CFM.

Do not spray cleaners directly to the control while cleaning the Hood. The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products. Do not use chlorine base cleaners. DO NOT USE ALCOHOL!

WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations.

The grease filter traps cooking grease particles. This must be cleaned once a month using non-aggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. To remove the grease filter, pull the spring release handle (A).

The LED lights are replaceable by a service technician only. See “Who to contact” section in the warranty for service contact information.

NOTE: When used in recirculation mode, To Reduce the Risk of Fire and Shock use only conversion kit Models: Recirculating kit: KITO2766.

If the model is not vented to the outside, the air will be recirculated through disposable charcoal filters that help remove smoke and odors.

1. Cover the grill that protects the suction motor with the carbon filter so that the slots on the filter correspond to the pins on the sides of the motor protection grill.

2. Turn the carbon filter clockwise to block them (bayonet fixing).

NOTE: The charcoal filters cannot be cleaned. It should be replaced every 4-6 months (depending on hood usage).

Owner must present proof of original purchase date. Please keep a copy of your dated proof of purchase (sales slip) in order to obtain service under warranty.

To obtain service under warranty or for any service related question:

USA & CANADA – Western Provinces
SERVICE POWER
888 732 8018
elica@servicepower.com

CANADA – Ontario Province
AGI Services
888 651 2534
service@agintl.qc.ca

CANADA – Quebec & Atlantic Provinces
Ateliers G. Paquette
800 463 0119
service@ateliersgpaquette.com

To ensure prompt after-sales service, when you call we will kindly ask you to provide the following information indicated on the nameplate inside the hood: hood model, 12 NC and date of purchase on original invoice. To access the nameplate, all you have to do is remove the grease filters.