Free English EGO COMMERCIAL AB5301 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD EGO COMMERCIAL AB5301 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
What safety precautions should be taken when replacing the EGO COMMERCIAL AB5301 blade?
Always protect your hands by wearing heavy gloves or wrapping the cutting edges with rags or other materials when performing any maintenance on the mower blades. Always remove the battery pack when servicing or transporting the mower.
What tools are needed to replace the EGO COMMERCIAL AB5301 blade?
The following tools (not included) are required for the replacement of the EGO COMMERCIAL AB5301 blade:
■ 9/16″ (14 mm) wrench or adjustable wrench (impact wrench with 9/16″ (14 mm) socket is recommended)
■ Torque wrench with 9/16″ (14 mm) socket
■ Manual screwdriver or metal rod with a diameter of 5/16″ (8 mm) or slightly less
■ Manual screwdriver or metal rod with a diameter of 1/4″ (6.35 mm) or slightly less
How do I remove the blade for the EGO COMMERCIAL AB5301?
1. Stop the motor, remove the battery pack(s) and grass bag from the mower.
2. Turn the mower on its side.
3. Insert a metal rod (stabilizer 1) of 5/16 in (8 mm) diameter or slightly less into the stabilizer hole to prevent the blade from rotating when loosening the bolt.
4. Use the wrench to turn the blade bolt COUNTERCLOCKWISE to loosen and remove the bolt.
5. Remove the outer flange and the blade.
6. Leave the fan on the motor shaft.
What should I do if the bolt rotates with the motor shaft when trying to remove the EGO COMMERCIAL AB5301 blade?
If the bolt rotates with the motor shaft when loosening the bolt, place another metal rod with a diameter slightly under 1/4 in (6.35 mm) into the aligned holes of the blade and fan to act as stabilizer 2.
How do I install the new EGO COMMERCIAL AB5301 replacement blade?
NOTICE: To re-install or replace the blade, be sure to replace the parts in the exact order in which they were removed.
1. Position the blade onto the inner flange of the fan with the surface marked “THIS SIDE FACING GRASS” facing toward the outside.
2. Align the outer flange with the shaft and assemble it in place.
3. Mount the bolt into the shaft and finger-tighten the bolt CLOCKWISE.
4. Insert the 5/16 (8 mm) metal rod to act as a stabilizer 1.
5. Use the torque wrench to tighten the bolt CLOCKWISE. The recommended torque for the blade bolt is 36-43 ft-lb (50-60 N m).
What is the recommended torque for tightening the blade bolt on the EGO COMMERCIAL AB5301?
The recommended torque for the blade bolt is 36-43 ft-lb (50-60 N m).
What should I do if the bolt rotates with the motor shaft when tightening the EGO COMMERCIAL AB5301 blade?
If the bolt rotates with the motor shaft when tightening the bolt, place another metal rod with a diameter slightly under 1/4 in (6.35 mm) to act as stabilizer 2.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
CLICK HERE TO DOWNLOAD EGO COMMERCIAL AB5301 (01) PDF DOCUMENT