DELI T100 (01) PDF Document

To ensure safe operation of your DELI T100 laminator, please adhere to the following warnings:

Warning! Keep out of the reach of children.

Warning! Do not touch the pouch inlet with your hand during operation.

Warning! Do not touch the surface of the machine with your hand during operation.

Warning! Please be cautious of hot surface during operation.

Warning! Please do not allow tie, necklace, sleeves, etc. to get pulled into the pouch inlet.

Warning! Please do not allow your hair to get pulled into the pouch inlet.

Warning! Do not disassemble or repair the machine by yourself in any way, to avoid electric shock or accidental injury. In case an item gets pulled into the laminator and the machine fails, please unplug the power cord and contact your dealer or after-sales service center.

Warning! Do not splash water onto the machine, to avoid a fire or electric shock.

Warning! Do not operate the machine with wet hands, to avoid electric shock or accidental injury.

Please follow these electrical safety precautions when using your DELI T100:

1. The plug on the power supply cord is intended to serve as the disconnect device. The socket-outlet shall be installed near the equipment and shall be easily accessible.

2. The appliance shall be connected to a MAINS socket outlet with a protective earthing connection.

3. Be sure to use an AC230V power supply.

4. When operating the power switch, please make sure that the power plug is properly inserted into the power socket to avoid damage to the machine. (There will be a crisp crackling sound when the switch is in good contact).

5. Do not damage or process the power cord or place objects on the power cord, to avoid a fire or electric shock.

6. Do not use the laminator if the machine or power cord is damaged.

7. Always unplug the power plug before moving the laminator.

In case of a power outage during operation: Please pull out the item being laminated evenly within a short time, and unplug the machine to avoid fire or electric shock.

In case of smoke, odor or other abnormal conditions: Please turn off the power switch immediately and stop using the DELI T100 to avoid a fire or electric shock.

For safe and effective use, please follow these placement guidelines for your DELI T100:

(1) Do not put the machine in a damp place or near an air conditioning vent to avoid dangerous accidents such as electricity leakage and insulation failure.

(2) Please ensure the machine is on a flat and level surface, and leave enough space on the side of the pouch outlet.

(3) Please do not place anything on top of the laminator.

(1) It is recommended to use the laminating pouches of our company. A pouch of other specifications or defective pouches may get caught in the laminator.

(2) It is recommended to use a laminating pouch 5-6mm larger than the item to be laminated. Inappropriate sized pouches will affect the lamination effect negatively. If there is no pouch with the right size, a larger pouch may also be used. Please place the item within pouches centered and trim it after lamination.

Lamination is conducted through heating and pressurization. The laminating pouch might be rolled up into the machine due to incorrect operation. Therefore, please do not laminate the following items with your DELI T100:

(1) Inflammable and heat sensitive materials (e.g. plastic bags, etc.)

(2) Important and unique documents.

(3) Items with a thickness of more than 0.5mm (inclusive of the laminating pouch).

(4) Items that will discolor or deteriorate after heating such as heat-sensitive paper and the paper with patterns drawn with crayons.

Please DO NOT operate the DELI T100 as below:

(1) Place the open end of the pouch into the machine.

(2) Place the pouch into the machine at an angle.

(3) Put the item to be laminated into an inappropriate sized pouch, and leave too much space around your contents.

(4) The original items to be laminated are undulating or curled.

(5) Two consecutive pouches are connected together.

(6) Cut the pouch before use.

(7) Use deformed laminating pouches.

(8) The length of the item to be laminated is less than 65mm.

The DELI T100 product diagram shows the following parts:

(1) POUCH INLET

(2) WORKING STATUS INDICATOR

(3) POWER CORD

(4) RELEASE

(5) POUCH OUTLET

(6) PLASTIC TRAY

1. Power on:

Connect the power cord. The working status indicator is red, and the machine is in the preheating state.

2. Laminating:

> Use the thermal laminating pouches in 70mic~100mic.

> The status indicator will turn green after preheating for about 5 minutes, and then you can use the machine.

3. Power off:

Unplug the power cord when you finish laminating the document.

If the pouch does not feed correctly or jams, unplug the power cord and press the release button. The pouch can then be backed out of the laminator by pulling with your hands.

1. Cleaning rubber roller: After long-term use, molten plastic residue can stick to the rubber roller, which can cause jams. To clean it, feed medium-thick sheets (such as calendar paper or catalog paper) through the machine several times using hot lamination. This should be done without the paper being inside a pouch.

2. Cleaning of the laminator: Please unplug the machine before cleaning. Gently wipe it with a soft cloth slightly dampened with water. Do not use solvents such as gasoline, alcohol, or diluent. Never use a metal brush, tool brush, or shovel to tap the rubber roller, so as to avoid scratching it.

3. Storage: Please protect your laminator from dirt with an appropriate dust cover when it’s not in use for an extended period of time.