Post questions, comments, reviews or errors in the comment box below.

Your File is Ready … Download PDF



WARNING IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: READ AND FOLLOW ALL INSTRUCTIONS WARNING - RISK OF ELECTRIC SHOCK - The pump cannot be using while people are inside the pool. WARNING - TO REDUCE THE RISK OF INJURY, do not permit children to use this product unless they are closely supervised at all times. WARNING - RISK OF ELECTRIC SHOCK. Connect only to a grounding type receptacle. This product is provided with a ground-fault circuit-interrupter. If replacement of the plug is needed, use only identical replacement parts. WARNING: The unit is provided with a ground-fault circuit-interrupter (GFCI). To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power should be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to the pump without the test button being pushed, a ground current is flowing, indicating the possibility of an electric shock. Do not use this pump. Disconnect the pump and have the problem corrected by a qualified service representative before using. CAUTION - To reduce the risk of electric shock the pool must be installed no closer than 6 feet (1.8 m) from any electrical outlet. Do not place portable appliances closer than 5 feet (1.5 m) from the pool. WARNING: The pump is not intended to be bonded to the equipotential bonding grid. DO NOT BURY CORD. Locate cord to minimize abuse from lawn mowers, hedge trimmers, and other equipment. WARNING - To reduce the risk of electric shock, IF FILTER PUMP POWER CORD BECOMES DAMAGED IN ANY WAY, THE PUMP MUST BE DISCARDED. WARNING - To reduce the risk of electric shock, do not use extension cord to connect unit to electric supply; provide a properly located outlet. CAUTION - This pump is for use with storable pools only. Do not use with permanently-installed pools. A storable pool is constructed so that it is capable of being readily disassembled for storage and reassembled to its original integrity. A permanently-installed pool is constructed in or on the ground or in a building such that it cannot be readily disassembled for storage. CAUTION - For continued protection against possible electric shock this unit is to be mounted to the base in accordance with the installation instructions. IMPORTANT - Using the pump with an unmatched electrical supply is dangerous and will result in catastrophic failure of pump. RISK OF ELECTRIC SHOCK - When working with electricity, turn the electrical power off at the circuit breaker and lock breaker door. Failure to do so will result in increased risk of shock, injury and possibly death. 2 S-S-005774 NNNNNCWCCCWSA

S DO NOT REMOVE THE GROUNDING PRONG OR MODIFY THE PLUG IN ANY WAY. DO NOT USE ADAPTOR PLUGS. Consult a qualified electrician for any questions related to the validity of your plugs grounding. Handle the pump with care. Do not pull or carry the pump by the power cord. Never pull a plug from the outlet by yanking the power cord. Keep cord free from abrasions. Sharp objects, oil, moving parts, and heat should never be exposed to the filter pump. NOTE: Please examine equipment before use. Notify Bestway at the customer service address listed on this manual for any manufacturing defect or missing parts at the time of purchase. Verify that the equipment components represent the filter pump model that you had intended to purchase. NOTE: Place pump on a solid and level ground. Pay attention to position of pool and pump so adequate ventilation, drainage, and access for cleaning is available. Never place pump in an area that may accumulate water, or in an area where foot traffic will flow around the pool. NOTE: Atmospheric conditions may affect the performance and life span of your filter pump. Unnecessary wear and tear may occur during periods of cold, heat and exposure to sun. Whenever possible shelter the pump from these conditions. NOTE: Do not add chemicals in the filter pump. NOTE: Assembly and disassembly of this product should only be performed by adults. • THERMALLY PROTECTED MOTOR CSA ENCLOSURE 3. • FOR USE WITH SWIMMING POOLS ONLY. • CAUTION: TO ENSURE CONTINUED PROTECTION AGAINST SHOCK HAZARD, USE ONLY IDENTICAL REPLACEMENT PARTS WHEN SERVICING. • WARNING: RISK OF ELECTRIC SHOCK. CONNECT ONLY TO A GROUNDING TYPE RECEPTACLE. • CAUTION: THIS PUMP IS FOR USE WITH STORABLE POOLS ONLY - DO NOT USE WITH PERMANENTLY-INSTALLED POOLS. • CAUTION: CONNECT ONLY TO GROUNDING TYPE RECEPTACLE PROTECTED BY A CLASS A GROUND FAULT CIRCUIT INTERRUPTER. • CAUTION: FOR CONTINUED PROTECTION AGAINST POSSIBLE ELECTRIC SHOCK THIS UNIT IS TO BE MOUNTED TO THE BASE IN ACCORDANCE WITH THE INSTALLATION INSTRUCTIONS. • WARNING - RISK OF ELECTROCUTION 1) Connect Only To Properly Grounded Outlet. Do Not Remove Ground Pin. 2) Inspect Cord Before Using – Do Not Use If Cord Is Damaged. 3) Keep Ground-Fault Circuit-Interrupter Dry And Off The Ground. 4) Do Not Touch Plug With Wet Hands. 5) Double Insulated – When Servicing Use Only Identical Replacement Parts. 6) Read Instruction Manual Before Using. DO NOT REMOVE THIS TAG SAVE THESE INSTRUCTIONS. 3 S-S-005774

A B C P6112 P6113 P6(H1)115 P6117 P6119 90357 P6(H1)727E P6019 P6(H1)517 P6124 P6005 P6029 P4(H1)134 P61408 P6680 1111111111111111111112201114202203321111102 0 0 X1X2 X2 1 2 3 4 X3 X1 X1 A P6019 B B P6019 P61408 A B B P6(H1)517 P4(H1)134 A BAAB B B A B B A B B P6680 P6124 P6112 P6113 P6(H1)115 P6117 P6119 90357 P6029 P6(H1)727E P6124 P6019 P6029 P6005 P61408 P6680 P4(H1)134 P6(H1)517 AB BC A B 4 S-S-005774 A B

1 2 3 A B A B P6(H1)517 A B Operation 1) Open/unscrew the Air Purge Valve (P6112) on the top of the Filter Pump; air is released as water fills the Filter Pump. 2) When water comes out of the Air Purge Valve (P6112) screw it closed and wipe away any water. NOTE: You must clean the filter cartridge every day and open the top valve let the air out then close it before using the pump, otherwise the pump may not work. AB AP4(H1)134 B A B B A 250 163 2-M8 bolt 390 2-M8 nut 390 163 Fig.1 PEDESTAL FIXING Fig.1 EN60335-2-41 TEST standard requires the filter pump must be vertically fixed on ground or a certain pedestal made of wood or concrete before use. There should be two holes 9mm in diameter on the pedestal, the space between which should be 163mm. Put filter pump on the pedestal and fix them together by fasten the bolts and nuts. All the pedestal parts should weigh over 18kgs at least to prevent the pump from accidental falling. 5 S-S-005774



A. To test the GFCI plug, insert it into a grounding type receptacle. B. NOTE: Press the “RESET” button; If the the indicator indicator turns light red. is not on, the test has failed. C. Press the “TEST” button. The indicator turns off. NOTE: If the indicator light is not off, the test has failed. D. Press the “RESET” button, the indicator light turns red, and the filter pump is ready for use. WARNING: RISK OF ELECTRIC SHOCK. THE GFCI MUST BE TESTED BEFORE EACH USE.WARNING: DO NOT USE THE PUMP IF THE ABOVE TEST FAILS. Please contact your local Coleman Aftersales Service. NOTE: plugging-in the To Filter prevent Pump. the risk of electrical shock, ensure your hands are completely dry when IMPORTANT: DO NOT DRY RUN THE FILTER PUMP - Make sure both the pool’s Inlet and Outlet valves are fully covered by water before operating the Filter Pump. PUMP CAUTION: MAINTENANCE YOU MUST ENSURE THE FILTER PUMP IS UNPLUGGED BEFORE ANY MAINTENANCE OR STORAGE BEGINS OR SEVERE RISK OF INJURY OR DEATH EXISTS. 1) Unplug the Filter Pump. 2) Stop water flowing to the Filter Pump refer to pool’s manual. 3) Unscrew the Filter Cap Retainer and remove the Filter Cap. 4) Clean the Filter Cartridge with a garden hose.If filter cartridge remains soiled or discolored, it is necessary to replace it with a new one. 5) Insert the cleaned (or new) Filter Cartridge; ensure it is centered in the Filter Pump. 6) Check that the Filter Cap Seal is in place. 7) Replace the Filter Cap and screw the Filter Cap Retainer into position. 8) Open the Valve A and B. 9) Follow the PUMP INSTALLATION DIRECTIONS section to prepare the system for use. IMPORTANT: For sanitary reasons we suggest To replacing ensure pool the Filter water Cartridge stays clean, with please a new clean one every the filter two cartridge weeks. every day. PUMP STORAGE 1) Unplug the Filter Pump. 2) Stop water flowing into the Filter Pump and to remove the Filter Cartridge. 3) Discard the Filter Cartridge. 4) Detach all Hoses. 5) Dry all components thoroughly. 6) Store the filter pump in a dry location out of the reach of children.Storage temperature: 4-40 oC (39.2-104F) 7) Drain the pool according to the Pool Owner’s Manual. PUMP WARRANTY For information concerning pump warranty please visit our website at: 6 S-S-005774 • LIMITED • 360 DAYS ON PUMP • WARRANTY • The product you have purchased comes with a limited warranty from the manufacturer Bestway®. Bestway® stands behind our quality guarantee and assures, through a replacement warranty, your product will be free from manufacturer’s defects. The limited warranty is valid as follows: 360 days for the motor pumps, 30 days for hoses, fitting and accessory included in the package, all from the original date of purchase. To file a warranty claim, please contact your Bestway® After Sales Center at 1-855-838-3888 before sending any documents. They will provide full instructions of what is needed for your claim. Bestway® is not responsible for economic loss due to water or chemical costs and will not replace any products deemed to have been neglected or used outside of the owner’s manual guidelines. Bestway’s warranty covers manufacturing defects discovered while unpacking the product or during use, as recommended within the user manual. This warranty applies only to products that have not been modified by any 3rd parties. The product must be stored and handled in accordance with the technical recommendations. The warranty does not cover damages caused by misuse, abuse, neglect, including but not limited to: collision, fire, excessive heat exposure, improper use of chemicals, exposure to extreme weather conditions, improper installation, or improper storage. Replacements and repairs don’t extend the duration of warranty. The warranty start date is the date of sale shown on the original receipt/ purchase invoice. Please copy the Batch Number found on the body of the filter pump. Batch Number Batch Number Batch Number

BATCH NUMBER: Date of purchase: TO: Bestway® Service Department Date: Website: Customer Code Number:

Toll-Free:1-855-838-3888 Please provide your address details in full. Note: Incomplete address details will result in delayed shipments. Bsetway® reserves the right to charge for redelivery of undelivered packages where the recipient is at fault. REQUIRED INFORMATION - PLEASE WRITE THE SHIPPING ADDRESS

Name: Address:

City: Country / State: Zip code: Retailer:

Mobile: Telephone: Fax: E-mail: Please Clearly Write Your Item Code:

POOL FILTER PUMP MODEL #XXXXX Item Code IMPORTANT: ONLY THE DAMAGED PART WILL BE REPLACED, NOT THE COMPLETE SET. Bestway® reserves the right to request photographic evidence of defective parts, or to require sending the item for additional testing. In order to best assist you, we request all information you provided to be complete. FOR FAQ, MANUALS, VIDEOS OR SPARE PARTS, PLEASE VISIT OUR WEBSITE: VIDEOS ARE ALSO AVAILABLE ON OUR BESTWAY CHANNEL ON YOUTUBE: 7 S-S-005774 © 2015 The Coleman Company, Inc. and are registered trademarks of The Coleman Company, Inc., used under license. Manufactured by ©2015 Bestway (USA) Inc., 3411 E. Harbour Drive, Phoenix, Arizona 85034, United States of America ®TM Trademarks used in some countries under license to Bestway Inflatables & Material Corp., No.3065 Cao An Road, Shanghai, 201812, China S-S-005774







Leave a Reply