CISCO SF110D-05 (01) PDF Document

The package for the CISCO 110 Series Unmanaged Switches typically includes:

• The Cisco 110 Series Unmanaged Switch

• Power adapter and power cord

• Rack-mount kit (brackets and screws)

• Documentation or Quick Start Guide

The following safety instructions are included for rack mounting:

A) Elevated Operating Ambient – If installed in a closed or multi-rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient. Therefore, consideration should be given to installing the equipment in an environment compatible with the maximum ambient temperature (Tma) specified by the manufacturer.

B) Reduced Air Flow – Installation of the equipment in the rack should be such that the amount of air flow required for safe operation of the equipment is not compromised.

C) Mechanical Loading – Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due to uneven mechanical loading.

D) Circuit Overloading – Consideration should be given to the connection of the equipment to the supply circuit and the effect that overloading of the circuits might have on overcurrent protection and supply wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing these concerns.

E) Reliable Earthing – Reliable Earthing of rack-mounted equipment should be maintained. Particular attention should be given to supply connections other than direct connections to the branch current (e.g. use of power strips).”

To install the CISCO SF110D-05, you can either set it on its four rubber pads on a flat surface or mount it on a wall using the wall-mount slots on the bottom panel of the switch.

To use the wall mount option, follow these steps:

Step 1: Attach two screws to the wall such that the wall-mount slots of the switch lineup with the two screws. The wall-mount slots are two criss-cross slots on the bottom panel of the switch.

For the CISCO SF110D-05, the screws should be 1.7 in (43 mm) apart.

Step 2: Maneuver the switch to insert the screws into the two wall-mount slots.

The following screw dimensions are recommended for the SF110D-05 model group:

To power on the switch, connect the provided power cord to the power port on the back of the switch and then plug the other end into a standard electrical outlet.

The recommended ambient temperature range for the CISCO SF110D-05 is 32° to 122° F (0° to 50° C).

The CISCO SF110D-05 has built-in diagnostics for cables which can detect cable issues upon connection to the port. It provides network integrity and can detect loops within the network when storm conditions are discovered. For best detection accuracy, please use a minimum cable length of 10 meters (~30 feet).

Cable Diagnostic Output:

• A physical cable fault enables the amber LED to light up continuously.

• Loop detection will enable the periodic blinking of the amber LED.

Procedure:

STEP 1: Ensure that the switch is powered on.

STEP 2: With the suspected cable connected to the switch, look at the pertinent interface’s LED outputs. A solid amber LED indicates a cable fault or open end. A blinking amber LED indicates a loop.