CHIEF SSM-011 (01) PDF MANUAL


Post questions, comments, reviews or page errors in the comment box below.

Your File is Ready … Download PDF

CLICK HERE TO DOWNLOAD CHIEF SSM-011 (01) PDF MANUAL


PDF Content Summary: INSTALLATION INSTRUCTIONS SSB-011, SSM-011, SLB-011 and SLM-011 Interface Brackets SSB-011, SSM-011, SLB-011 and SLM-011 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific installation instructions provided with the mount for additional installation information. Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative. WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer! (1) Interface Bracket (3) M3 -12mm Screws (4) 10 - 24 Thumb Nuts** (3) M3 Flat washers (1) All-Points Security Kit

Towards front of SLB-011 SLM-011 projector Towards front of projector

(Note: SSB-style interface bracket connections are encircled) **Only used when installing SLB/SSB interface brackets. (Note: SSM-style interface bracket connections are encircled)

NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style interface bracket installation. Installation Instructions WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface bracket. NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2. 1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time. 2. Turn projector upside down on a flat surface. 3. Remove the two screws on the bottom of the projector holding the front cover and remove the screw located in the center of the back of the projector. 4. Place the interface bracket onto the bottom of the projector and align the three mounting holes in the bracket with the three threaded inserts in the projector. 5. Using the three M3 x 12mm screws and M3 flat washers, secure interface bracket to projector and tighten all fasteners at this time. NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation instructions in the All-Points Security Kit. Chief® is a registered trademark of Milestone AV Technologies. All rights reserved. Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.

Chief Manufacturing, a products division of Milestone AV Technologies 8802-000048 Rev01 8401 Eagle Creek Parkway, Savage, MN 55378 • P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918 ©2009 Milestone AV Technologies, a Duchossois Group Company 05/09


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL

Leave a Reply