CHICCO FASTLOCK GO (01) PDF Document

Failure to follow all warnings and instructions could result in serious injury or death.

Fall Hazard. To prevent falls:

ALWAYS use restraints. Adjust to fit snugly.

Keep child in view.

To prevent tipover, check stability of table before and after seating child.

Additional Warnings:

Discontinue use if child, when seated in hook-on chair, is able to move the hook-on chair arms on the table top.

Before removing child from hook-on chair, be sure child’s legs are free from hook-on chair lower arms.

Discontinue use if hook-on chair is broken or missing any components.

Do not use without all rubber on the arms attached securely to table surface.

Keep table and seat clean and dry to prevent slipping.

Do not allow other children to play near or walk under hook-on chair while in use.

Do not use replacement parts other than those approved by Chicco.

Frequently check the arm clamps and tighten them if required.

Do not attach objects to the hook-on chair, since they might affect the stability and safety of the product.

Do not fit or lock the hook-on chair to a table with the child sitting in the hook-on chair.

Do not seat more than one child at a time in the hook-on chair.

Do not attach the hook-on chair to drawers or movable parts of tables.

Before use, remove and dispose of all plastic bags and packaging materials and keep them out of reach of children.

Keep hot liquids/foods away from table while child is in hook-on chair.

Use only for:

Child who can sit upright without help.

Child up to 37 pounds (16.8 kg).

Tables 3/4 to 1 1/2 in. thick (19 to 38 mm).

NEVER use with:

glass table top

loose table top

single pedestal table

card table

table leaf

table cloths or placemats

Child can use nearby structures to kick or push chair off. NEVER use hook-on chair:

with ordinary chair underneath

in reach of table legs

near island below countertop

The CHICCO FASTLOCK GO includes the following components:

A. – Hook-On Chair Seat and Frame Tube

B. – Arms

C. – Tray

1. Match up the Arms ‘A’ and ‘B’ with the corresponding letters on the Chair Frame.

2. Press in the Snap Buttons on both sides of an Arm and insert it into the Chair Frame, making sure the Snap Buttons are secured in the cutouts. Repeat for the other side.

3. Press in on the ‘RELEASE’ Snap Button on the outside of each Arm and rotate the Arm in. Repeat for the other side.

4. Using the finger loop, pull the fabric strap down and around the front of the Arm’s downtube. Hook the smaller loop over the metal pin on the outside of the Arm to secure it. Repeat for the other side.

5. Rotate the Arms out and flip the Hook-On Chair over. Make sure the Arms are back in the ‘LOCKED’ position.

1. If the Clamp Bar is up, it must be lowered all the way. To lower it, push in on the release button on the front of the Arm. The Clamp Bar may need to be pushed down while pressing the release button.

2. The Locking Clamps must be rotated inward before you attach the chair. Twist the Locking Clamps in.

3. Slide the Hook-On Chair onto the table top. Make sure the Upper Arm Grips are completely on top of the table and the Lower Locking Arms are folded downwards and below the table top.

4. Rotate both Locking Clamps up until they click into an upright position. Check to make sure both Locking Clamps are fully rotated up and that the alignment arrows are matching up on the Lower Locking Arms.

5. If the underside of your table has an apron, make sure the Lower Locking Arms are completely past it before securing.

6. Check to make sure there is not a gap between the Arms and the edge of the table.

7. To secure the chair, squeeze the ratchet button until the clamp bar meets the underside of the table. Repeat for the other side. Check to make sure that the arms on the table top are flat and that the Hook-On Chair is secure.

WARNING: Pull/Push on hook-on chair to make sure it is firmly attached to table.

To attach the Tray: Line up the Tray with the slots in the Upper Arms. Push down firmly on both side tabs to snap the Tray into place. You should hear a “CLICK”.

To remove the Tray: Grasp the Tray by the tabs on each side and pull up.

WARNING: Always secure child in the restraint. Never leave child unattended in hook-on chair. Always keep child in view.

1. To secure: Slide both Waist Clips into the Crotch Strap Buckle. Pull on both sides to make sure the Clips are secured to the Buckle.

2. To release: Press the button on the center of the Crotch Strap Buckle and pull both Waist Clips out.

3. To adjust: The length of the Waist Straps can be adjusted by pressing the tab at the end of the Waist Strap Clip and pulling on the strap to tighten or loosen to better fit your child.

1. Push in on the release buttons on the front of the Lower Locking Arms to unlock the Clamp Bars. Tip: If the release button is hard to push, lightly squeeze the ratchet button and press the release button at the same time.

2. Rotate the Locking Clamps down and slide the Hook-On Chair off of the table top.

1. Press in on the ‘RELEASE’ Snap Button on the outside of the Arm and rotate the Arm in.

2. Repeat for the other side.

WARNING: Do not use the hook-on chair with the carry bag hanging down.

1. Flip the seat over; locate and remove the carry bag from the pocket on the bottom of the seat pad. Unfold the carry bag completely.

2. Grab both handles of the bag and pull the carry bag around the folded Hook-On Chair.

Important: When not using the carry bag, store the carry bag into the pocket on the seat bottom.

1. Press in on the ‘RELEASE’ Snap Button on the outside of an Arm and rotate the Arm in. Repeat for the other side.

2. Flip the Hook-On Chair upside down and unhook both fabric straps from either Arm.

3. Press in on BOTH Snap Buttons on an Arm and pull the Arm out to remove it from the frame. Repeat for the other arm.

4. Pull the seat frame tube out of the fabric.

5. Locate the seat board inside the seat bottom pocket. Unbuckle the safety harness, lift up on the back edge of the seat fabric, and pull out the seat board.

To replace the fabric seat cover, follow these steps in reverse. Note: When replacing the seat board back into the pocket, make sure the rounded edges of the board are aligned with the rounded edges of the seat pocket.

The cleaning and maintenance of the Hook-On Chair must only be carried out by an adult.

CLEANING

The fabric seat can be removed for cleaning. Please refer to the care label on the fabric seat for instructions on how to clean.

It is recommended to periodically clean between the movable and fixed plastic parts of the seat with a toothbrush to remove any possible food residues. Always dry the metal parts to prevent the formation of rust.

Plastic can be cleaned with mild detergent and warm water; do not use bleach or harsh cleaners/abrasives.

MAINTENANCE

This product requires regular maintenance. Periodically check the Hook-On Chair for wear, damage, or missing components. Should any parts be missing or damaged, the Hook-On Chair must not, under any circumstances, be used.