CHAMBERLAIN LIFTMASTER PROFESSIONAL 970CF (01) PDF MANUAL

CHAMBERLAIN LIFTMASTER PROFESSIONAL 970CF (01) PDF SUMMARY:

How do I program the remote control?

The programming instructions are described and illustrated. The additional push buttons can also activate other garage door openers and/or light controls. (Instructions for programming light products are included with those accessories.).

How do I program the remote control to the garage door opener?

1. Press and release the “learn” button on the motor unit. The learn indicator light will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the button on the hand-held remote.
3. Release the button when the motor unit light blinks. It has learned the code. If light bulbs are not installed, two clicks will be heard.

How do I erase all codes from the motor unit memory?

To deactivate any unwanted remote, first erase all codes by pressing and holding the “learn” button on the motor unit until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.

How do I control the opener lights with SECURITY✚ transmitters?

A remote push button can be programmed to operate the opener lights without opening the door.

1. With the door closed, press and hold the remote button that you want to control the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the opener lights flash, release all buttons.

Test by pressing the remote push button. The opener lights should turn on or off but the door should not move.

How do I set up the Security✚ remote control to open, close, and stop the garage door?

Your Security✚ remote control can be programmed to operate one door using all 3 buttons: the left button will only open the door, the middle button will only close the door, and the third button will stop the door’s movement. You may set up this feature as follows:

1. With the door closed, press and hold the left remote push button.
2. Press and hold the Lock button on the door control.
3. Press and hold the door control push bar.

When the opener lights flash, release all buttons. Test by pressing the left (Open) button on the remote. The door should open. Press it again while the door is open and nothing should happen. Press the middle (Close) button and the door should close. Press the third (Stop) button while the door is moving and it should stop immediately.

What warnings should I be aware of regarding the use of remote controls?

To prevent possible serious injury or death from a moving gate or garage door:

• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play with remote control transmitters.
• Activate the gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
• ALWAYS keep the gate or garage door in sight until completely closed. NEVER permit anyone to cross the path of a moving gate or door.

How do I replace the remote control batteries?

The lithium batteries should produce power for up to 5 years. To replace, pry open the case as shown. Insert batteries positive side up (+). Dispose of old batteries properly.

What are the warnings related to remote control batteries?

To prevent possible SERIOUS INJURY or DEATH:

• NEVER allow small children near batteries.
• If a battery is swallowed, immediately notify a doctor.

What is the FCC notice regarding adjustments and modifications?

To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.