Free English CERWIN VEGA V469 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD CERWIN VEGA V469 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the power handling specifications for the CERWIN VEGA V469?
| Model | Type | Power Handling |
|---|---|---|
| CERWIN VEGA V469 | 6 x 9 inch 2-way coaxial speaker | 500W MAX / 100W RMS POWER HANDLING |
What are the recommended installation methods for the CERWIN VEGA V469?
The CERWIN VEGA V469 is designed with the flexibility to be installed in multiple locations. To ensure the best performance, it is important to isolate the front sound waves from the rear sound waves by securely mounting the speaker to a flat surface known as a baffle, ensuring there are no air leaks around its frame.
If your vehicle has existing factory speaker locations, replacing them with the CERWIN VEGA V469 is the easiest method. If you are performing door mounting where there is no factory location, you must remove the door panel and check for clearance in the intended area to ensure the window operates without interference and that you avoid cutting structural metal supports or braces.
For rear deck mounting, there are two primary methods: top mounting and bottom mounting. Top mounting requires dropping the speaker through the deck from the interior, while bottom mounting secures the speaker from underneath the trunk. Either method requires a good seal around the frame for the best performance.
What precautions should be taken when running new wiring for the CERWIN VEGA V469?
If you need to run new wires for your CERWIN VEGA V469 rather than using the factory wiring, follow these precautions:
1. Always use a grommet if the wire needs to run through metal, such as a door jamb, to prevent damage to your wires.
2. Never run wire through bare metal as this can damage the source unit, the amplifier, or the speakers themselves.
3. Always remember that the safety of the wiring against short circuits is the most important installation concern.
CLICK HERE TO DOWNLOAD CERWIN VEGA V469 (01) PDF DOCUMENT