Free English CERWIN VEGA V468 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD CERWIN VEGA V468 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the specifications for the CERWIN VEGA V468?
| Model | Type | Power Handling |
|---|---|---|
| CERWIN VEGA V468 | 6 x 8″ 2-way coaxial speaker | 400W MAX / 75W RMS POWER HANDLING |
How do I install the CERWIN VEGA V468 speakers?
The CERWIN VEGA V468 speakers were designed with the flexibility to be installed in multiple locations. To ensure the best performance possible, it is important to isolate the front sound waves of the speaker from its rear sound waves. This is done by securely mounting the speaker to a flat surface known as a baffle. Make sure to seal the speaker to ensure there are no air leaks around its frame.
How do I select the best location for my CERWIN VEGA V468 speakers?
If your vehicle has existing factory locations, the easiest method would be to replace them with the exact same size speaker. In the case where there is not a factory speaker location, there are many places where the speakers will fit in a vehicle, but they are not always the best locations for good sound. Make sure to take the time to select the best locations possible. Mounting the speakers so that they are equal distance from your ears will achieve the best results.
What should I know about door mounting the CERWIN VEGA V468?
Prior to cutting, remove the panel from the door and check for clearance in the in the intended installation area, making sure the window will go all the way up and down without any interference. Avoid cutting any structural metal support or braces to mount the speakers. It is highly recommended that for the best sound you put a sound deadening mat on the door skin. The more damped your car is, the better it will ultimately sound.
How do I perform rear deck mounting for the CERWIN VEGA V468?
There are two primary methods for mounting speakers in the rear deck of a vehicle, top and bottom mounting. Top mounting requires dropping the speakers in through the deck (interior) while bottom mounting secures the speakers from underneath (trunk). Either method requires a good seal around the frame for the best performance.
What should I consider when running new wiring for the CERWIN VEGA V468?
In most cases when mounting new speakers you will use the factory supplied wiring, but if new wires have to be run there are some precautions that need to be taken. If the wire needs to run through metal, such as a door jamb, always use a grommet to prevent damage to your wires. Never run wire through bare metal! This can damage the source unit, amp, or even the speakers themselves. Safety of the wiring against short circuits is the most important installation concern.
What are the special features of the CERWIN VEGA V468?
The special features include:
Fully encapsulated 12 dB per octave On-Board Crossover Network
1.0″ (25mm) Titanium Dome Tweeter
Proprietary Low resonance Deep Drawn Stamped Cast Basket
Curvilinear Cone Design for Superior Mid-Bass and Off Axis Performance
VEGA Signature Red Surround
CLICK HERE TO DOWNLOAD CERWIN VEGA V468 (01) PDF DOCUMENT