CAMRY CR 4626 (01) PDF DOCUMENT

Please read carefully and always comply with the following instructions for the CAMRY CR 4626:

1. The product is only to be used indoors. Do not use the product for any purpose that is not compatible with its application.

2. The applicable voltage is 220-240V, 50/60Hz. For safety reasons it is not appropriate to connect multiple devices to one power outlet.

3. Please be cautious when using around children. Do not let children play with the product or let people who do not know the device use it without supervision.

4. This device may be used by children over 8 years of age and persons with reduced physical, sensory or mental capabilities, only under the supervision of a person responsible for their safety.

5. Always remember to gently remove the plug from the power outlet holding the outlet with your hand. Never pull the power cable.

6. Never put the power cable, the plug or the whole device into the water. Never expose the product to atmospheric conditions such as direct sunlight or rain, and never use the product in humid conditions.

7. Periodically check the power cable condition. If the power cable is damaged, the product should be turned to a professional service location to be replaced.

8. Never use the product with a damaged power cable, if it was dropped or damaged in any other way, or if it does not work properly. Always turn the damaged device to a professional service location for repair.

9. Never put the product on or close to hot or warm surfaces or kitchen appliances like the electric oven or gas burner.

10. Never use the product close to combustibles.

11. Do not let the cord hang over the edge of a counter or touch hot surfaces.

12. Never leave the product connected to the power source without supervision. Even when use is interrupted for a short time, turn it off from the network and unplug the power.

13. For additional protection, it is recommended to install a residual current device (RCD) in the power circuit, with a residual current rating not more than 30 mA. Contact a professional electrician in this matter.

14. The exchange of accessories may only be carried out with the device switched off.

15. The blades are very sharp. The highest caution is offered. Before replacing the mixers, unplug the power cord from the wall outlet.

16. Only use original accessories that are included in the scope of supply.

17. Do not cover the ventilation openings in the housing during operation.

18. For washing the case, do not use any heavy cleaning agents.

19. Never use the appliance for hot oil or grease (hot products).

20. Never touch with wet hands.

21. The appliance is not intended for crushing ice, bone, and other hard products or for grinding nuts and coffee.

22. During the mixing process, never place your hands or cutlery into the container.

23. Observe the maximum uninterrupted operating time of the unit of 15 seconds. After the continuous operating time of 15 seconds, wait 3 minutes before turning the unit back on. Exceeding the operating time can lead to irreversible engine damage.

The CAMRY CR 4626 includes the following components:

1. BLENDER

a) ON/OFF switch, I speed

b) ON/OFF switch, II speed

c) motor part

d) blending shaft (removable)

2. CHOPPER

a) lid

b) chopping blade

c) chopper bowl

d) anti-slip rubber ring

3. WHISK

a) gearbox

b) whisk

4. BEAKER

5. MILK FROTHER

The hand blender is perfectly suited for preparing dips, sauces, soups, mayonnaise and baby food as well as for mixing and milkshakes.

1. Attach the blending shaft (1d) to the motor part (1c). Turn it until it is locked.

2. Place the blending shaft into the beaker (4). Then press the button I speed (1a) or II speed (1b).

3. During processing, always hold the blender with one hand and the beaker (4) in the other hand.

4. After use, unplug the device from a power socket. Remove the blending shaft (1d) from the motor part (1c).

The chopper is perfectly suited for food, such as meat, cheese, onion, herbs, etc.

1. Always place the chopper bowl (2c) on a flat, dry surface. Place the chopping blade (2b) on the center pin of the chopper bowl (2c).

2. Place the food in the chopper bowl (2c).

3. Cover the chopper bowl (2c) with the lid (2a). Press and turn it until it locks.

4. Attach the motor part (1c) to the chopper’s lid (2a). Turn it until it locks.

5. Press the desired speed button (1a) or (1b).

6. During processing, hold the blender with one hand and the chopper bowl with the other hand.

7. After use, unplug the device from a power socket. Detach the motor part (1c) from the lid (2a). Open the lid (2a) and carefully take off the chopping blade (2b).

Use the whisk only for whipping cream, beating egg whites and mixing sponges and ready-mix desserts.

1. Attach the whisk (3b) to the gearbox (3a). Turn it until it locks.

2. Attach the motor part (1c) to the assembled whisk.

3. Press the desired speed button (1a) or (1b).

4. During processing, hold the blender with one hand and the beaker (4) with the other hand. To avoid spreading, always mix more liquid contents in the beaker (4).

5. After use, release the speed button and remove the whisk attachment from the motor part (1c). Unplug the device from a power socket.

Use the milk frother to froth milk.

1. Attach the milk frother (5) to the gearbox (3a). Press gently by the tip of the frother.

2. Pull a little to check if it’s properly attached in the gearbox (3a).

3. To remove the milk frother attachment (5) from the gearbox (3a), pull it firmly by the tip by putting it between two fingers.

Never put the motor part (1c) into water and keep it away from wet. Before cleaning, always switch off the device and unplug it from the power socket.

1. Wipe the outside of the motor part (1c) with only a slightly moistened cloth and polish with a soft dry cloth.

2. Wash the detachable accessories in soap water, such as the blender shaft, whisk, and chopper blade. Do not use scouring pads for the plastic materials. Rinse them with clear water and dry them.

3. Do not clean with any abrasive scouring pad or steel wool, as this will damage the finish of the appliance.

Nominal power: 500W

Voltage: 220-240V, 50/60Hz

Max operating time: 15s, hard food- no longer than 10s

Time break before the re-use of device: 3min