BRAUN SILK-EXPERT 5 BD 5008 (01) PDF DOCUMENT

The BRAUN SILK-EXPERT 5 BD 5008 has been designed to effect long-term hair growth reduction after a certain period of treatment. Ideal body areas for use include:

Women: Legs, arms, underarms, bikini area and face (below cheek bones).
CAUTION: Do not use the device near the eyes and along the forehead.

Men: Shoulders and below (chest, back, arms, stomach, legs).
CAUTION: Do not use on the face, neck or genital area. Usage on male beards or facial hair may lead to permanent or uneven results which may produce changes in facial characteristics that may not be desirable.

The BRAUN SILK-EXPERT 5 BD 5008 is not suitable for everyone. It is most effective on light to medium skin tones and dark hair colors. It is not effective on red, very blonde, grey or white hair.

The device should not be used if your skin is darker than skin tone V as shown in the skin tone chart on page 3 of the user manual. Since dark skin absorbs more light energy, treating very dark skin may cause discomfort/pain and adverse effects (e.g., burns, blisters, discoloration or scarring) and injure your skin.

The intelligent SensoAdapt™ skin sensors continuously read your skin tone before every flash, automatically adapting the light intensity for best efficacy and safety. This allows treatment of appropriate skin tones but prevents treatment if your skin tone is too dark.

DO NOT USE the BRAUN SILK-EXPERT 5 BD 5008 under the following conditions (contraindications):

• if your skin is darker than skin tone V shown on the skin tone chart on page 3.

• if you are pregnant, lactating, or under the age of 18 as this device has not been tested with these individuals.

• if you have a history of skin cancer or precancerous lesions (e.g., nevi or a large number of moles).

• if your skin has been artificially or naturally tanned recently. Your skin may be extra sensitive following sun exposure and particularly susceptible to side effects of IPL treatment.

• You have a chronic medical condition.

• You have a chronic skin disease (e.g. psoriasis or vitiligo) or damaged skin (e.g. sunburn, cuts, open wounds or active infections) in the areas you wish to treat.

• You have varicose veins in the area you wish to treat.

• You have a known sensitivity to sunlight (photosensitivity) or are taking medication that may make the skin more sensitive (e.g. Retin A, Accutane and/or other topical retinoids).

• You have had a skin peel treatment on the area you wish to treat.

If you are unsure whether this device is safe for you to use, please consult your physician or dermatologist.

DO NOT USE on…

• scalp, eyebrows or anywhere near or around the eyes. Use in these areas may permanently damage your eyes.

• red, very blonde, grey or white hair. The device is not effective on these hair colors.

• nipples, genitals or around the anus. These areas may have a darker skin color and/or greater hair density and using the device in these areas may cause discomfort/pain or injure your skin.

• dark brown or black spots such as freckles, birthmarks, moles or warts in the treatment area.

• a tattoo or permanent makeup in the treatment area.

• beard / facial hair for men.

Additionally, DO NOT look directly into the glass filter or attempt to activate the device toward the eyes.

Preparing the treatment area:
Remove any visible hair on the skin before using the device. You may use your preferred hair removal method. Ensure there is no hair remaining above the surface of the skin as this can damage the removable front and may cause treatment discomfort. Clean the treatment area and pat it dry.

To power on the device:
Plug the mains cord into an electrical outlet. Plug the power supply into the power socket on the device. The LED power bars will light up once and a fan starts running. This means the device is in READY mode. During operation, the device will heat up slightly.

You can adjust the light intensity using the light intensity button (4):

• Normal setting: After plugging in, the device operates with full light intensity shown by a white indicator light.

• Gentle setting: Press the button once to operate with reduced light intensity. The indicator light shines blue.

• Extra gentle setting: Press the button a second time. The indicator light flashes blue.

To return to full power, press the button again. Gentle and extra gentle settings are meant for sensitive areas and first-time users. With reduced light intensity, more treatments may be required to see the desired effects.

When both skin tone sensors have skin contact, the BRAUN SILK-EXPERT 5 BD 5008 reads your skin tone and selects the appropriate light intensity, which is indicated by white LEDs on the Power bars. These confirm that the device is ready to flash. The display on the power bars indicates the following:

Before your first treatment, it is recommended to test your skin for reaction to the BRAUN SILK-EXPERT 5 BD 5008 on a small area of skin of the body part you plan to treat (about 2 x 3 cm in size; equivalent to the size of two flashes, side by side).

Perform a patch test using the «Precision mode» as described in the treatment modes section. Wait 48 hours to examine the test area. If the skin appears normal, you can begin your first treatment. If a skin reaction develops, discontinue using the device and consult your physician. Do not treat the patch tested area for at least one week after the test.

Depending on the area you wish to treat, you can choose between Gliding mode and Precision mode. Before pressing the treatment button, always look away from the device to avoid the bright light.

Standby mode
After 10 minutes of inactivity, the device will revert to standby mode (which will be indicated by one blinking light on the power indicator bars). To return to READY mode, press any key or remove/replace the power cord.

Sleep mode
If the device is not operated (no button push) for 60 minutes, it will enter sleep mode (low power state). The Power bar LEDs are off. To return to READY mode, press any key or remove/replace the mains cord. On wake-up the device will follow the standard Power on procedure (power bars will light up completely once).

The typical hair growth cycle varies and could take up to 16 months depending on the body area. Since only hairs in their growing phase are susceptible to treatment with light, it is important to do multiple treatments to achieve continuously smooth skin. For this reason, the following treatment plan is recommended:

In case you no longer see hair growing, you do not need to complete the full 12 weekly treatments. You can switch to the maintenance treatments.

Immediately After Treatment:

• Once you have completed your treatment, unplug the power supply from the electrical outlet to turn off the device.

• The skin tone sensors and the treatment window should be inspected for damage and wiped down with a dry, lint free cloth. If any marks or black spots are seen, clean them off straight away after treatment.

• Do not touch or clean the glass filter for at least 5 minutes after use to allow it to cool down.

Post-Treatment Skin Care:

• After treatment, we recommend using sunscreen SPF 15 whenever treated areas may be exposed to the sun. We recommend avoiding exposure to artificial light sources, such as tanning booths or solariums.

• Avoid any activity or skin products that may irritate your skin for 24 hours after treatment. This includes using hot tubs or saunas, wearing tight-fitting clothing, using bleaching creams, perfumed products or peeling products. The above may cause irritation, such as itching and redness, in the treated areas.

• After use, wipe down the device and especially the treatment window with a dry, lint-free cloth. Do not rinse or immerse the device in water or any other liquid.

• To ensure maximum performance, it is important to keep the treatment window reflector free from dirt, hair or other debris. To aid in the cleaning of this part, the front section is removable. Once removed, it can be cleaned with a slightly damp cloth. Always ensure the front section is completely dry before re-fitting it.

• Store the device in a cool, dry place. Make sure the treatment window and skin sensors are protected from damage.

Some people will experience slight discomfort (e.g. heat or redness of the skin) when using the device – this is normal. Adverse reactions are usually immediate or appear within 24 hours. In rare cases, they may take up to 72 hours to appear. If you experience abnormal skin reactions please contact your physician.

The following troubleshooting guide may help you solve initial problems you may experience with the BRAUN SILK-EXPERT 5 BD 5008.