BLOMBERG BRFD2230SS (01) PDF Document

To ensure efficient operation of your BLOMBERG BRFD2230SS, follow these guidelines:

1. Choose a place where you can use the product comfortably.

2. Install the BLOMBERG BRFD2230SS at least 30 cm away from heat sources such as hobs, ovens, heater cores, and stoves, and at least 5 cm away from electrical ovens.

3. Do not subject the product to direct sunlight or keep it in humid places after installation.

4. Provide appropriate air ventilation around the unit. If placed in a recess in the wall, leave at least 5 cm of distance between the product and the ceiling and side walls.

5. Do not place the product on materials such as rugs or carpets.

6. Place the product on an even floor surface to prevent jolts.

7. Do not install the product in places where the temperature falls below 10 degrees Celsius (50 degrees Fahrenheit).

8. If two coolers are to be installed side by side, there should be at least 4 cm of distance between them.

Connect the BLOMBERG BRFD2230SS to a grounded outlet protected by a fuse that complies with the values in the rating plate. The grounding installation should be performed by a qualified electrician. Ensure the electrical connection complies with national regulations and the power cable plug is within easy reach after installation.

The voltage and allowed fuse or breaker protection are specified on the rating plate affixed to the interior of the BLOMBERG BRFD2230SS. If the current value of the fuse or breaker in your home does not match, have a qualified electrician install a suitable fuse. The specified voltage must be equal to your mains voltage. Do not use extension cables or multi-plugs.

If the BLOMBERG BRFD2230SS stands unbalanced after installation, you can adjust the feet. First, unplug the appliance. Turning the front feet balances the product. The corner where the foot is located is lowered when you turn in the direction of the arrow and raised when you turn in the opposite direction. It is helpful to have someone assist you in slightly lifting the unit.

To attach the internal water filter in the BLOMBERG BRFD2230SS, follow these steps:

1. Pull the water filter cover slowly.

2. Ensure the “Ice Off” mode is enabled, then remove the water filter bypass cover by turning it downwards.

3. Seat the water filter cover into the mechanism and push forwards to lock it in place.

4. Press the “Ice Off” button on the display again to exit this mode.

Before using the dispenser on the BLOMBERG BRFD2230SS for the first time:

1. Connect the water system to a cold water line only; do not connect to a hot water line.

2. Air in the system may prevent water flow initially. Press the dispenser latch for 1 to 2 minutes until water flows. The flow may be irregular until air is fully discharged.

3. During initial use, wait approximately 12 hours for the water to cool down.

4. It will take 1 to 2 days for the system to produce the required amount of ice.

5. Do not consume the first 10 glasses of water.

6. Water might appear turbid during the first use due to the filter; do not consume these first few glasses.

7. If the dispenser has not been used for a long period, the first 1 to 2 glasses of water might be hot.

The automatic filter usage time calculation is not enabled from the factory. To activate the filter counter on the BLOMBERG BRFD2230SS:

1. After the unit is energized, verify that the cabin set values are visible on the display.

2. Press the “Alarm Off” button for 3 seconds.

3. The filter counter is then activated. After 3120 hours (130 days), the filter warning LED will light up. Pressing the “Alarm Off” button for 3 seconds will turn off the warning.

4. Once the filter is replaced, press the “Alarm Off” button for 3 seconds to reactivate the counter.

The BLOMBERG BRFD2230SS features an “Ice-Off” function to stop ice production. To activate it, press the “Freezer Set” button on the display for 3 seconds. The Ice-off icon will turn on, and ice formation will stop. To deactivate it and resume ice production, press the “Freezer Set” button again for 3 seconds; the Ice-off icon will go out.

Follow these guidelines to preserve food quality in your BLOMBERG BRFD2230SS:

1. Wrap food or place it in covered containers before storing it in the refrigerator.

2. Allow hot food and drinks to cool to room temperature before placing them in the BLOMBERG BRFD2230SS.

3. Freeze only fresh, high-quality food. Divide food into portions suitable for your family’s needs.

4. Pack food in an airtight manner to prevent drying. Packaging must be tear-proof and resistant to cold, humidity, odors, oils, and acids.

5. Do not freeze large quantities of food at once. The quality is best preserved when food is frozen to the core as quickly as possible.

6. Do not place warm food into the freezer compartment as it causes the cooling system to run continuously.

7. Thawing frozen food in the fridge compartment provides energy savings and preserves food quality.

Proper maintenance of the BLOMBERG BRFD2230SS extends its service life.

1. Always unplug the product before cleaning.

2. Do not use gasoline, benzene, or similar substances.

3. Do not use sharp or abrasive tools, soap, household cleaners, detergents, or wax polish.

4. Dissolve one teaspoon of carbonate in half a liter of water. Soak a cloth in this solution, wring it out, and wipe the interior of the BLOMBERG BRFD2230SS thoroughly before drying it with a clean, dry cloth.

5. Ensure no water enters the lamp housing or electrical components.

6. If the unit will not be used for a long period, unplug it, empty all food, clean it, and leave the door ajar.

7. Check the door gaskets regularly to ensure they are clean.

8. Never use cleaning agents or water containing chlorine for outer surfaces or chromium parts, as it causes corrosion.

For the BLOMBERG BRFD2230SS, the following weight limitations apply:

1. Freshfood compartment cantilever shelves (with rear supports only) are tested for a maximum of 25kg (55 pounds) per part.

2. Crispers can hold up to 15kg (33 pounds) each.

3. The chiller zone holds up to 20kg (44 pounds).

4. The ice container bin holds up to 10kg (22 pounds) (usage without ice).

5. The upper freezer bin holds up to 24kg (53 pounds).

6. The freezer drawer holds up to 30kg (66 pounds).

If the BLOMBERG BRFD2230SS fails to operate:

1. Ensure the power plug is fully seated in the socket.

2. Check if the fuse connected to the socket or the main fuse has blown; if so, replace or reset the fuse.

Condensation inside the BLOMBERG BRFD2230SS is often caused by the following:

1. Doors are opened too frequently. Reduce the frequency of opening.

2. The environment is too humid. Do not install the BLOMBERG BRFD2230SS in highly humid environments.

3. Food containing liquids is stored in unsealed containers. Keep all such food in sealed containers.

4. The door may have been left open for a long period. Close the door.

5. The thermostat may be set to too low a temperature; adjust it to the appropriate setting.

If your BLOMBERG BRFD2230SS is operating continuously, consider these factors:

1. The new product may be larger than your previous one, requiring longer run times.

2. Room temperature may be high, which is normal as the product will run longer in warmer conditions.

3. The unit may have been recently plugged in or loaded with a large amount of new food; it needs time to reach the set temperature.

4. Large amounts of hot food may have been recently placed inside; avoid adding hot food.

5. Doors are being opened too frequently or are ajar. Ensure doors are fully closed and limit openings.

6. The thermostat may be set too low; adjust it to a higher setting.

7. The door seal may be dirty, worn, or broken. Clean or replace the seal to ensure efficient cooling.