Free English AL-KO SOLO HT 3645 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD AL-KO SOLO HT 3645 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What should I do if the AL-KO SOLO HT 3645 motor does not start?
If the motor does not start, please check the following:
1. Check if the battery is flat and charge it if necessary.
2. Ensure the battery is inserted correctly.
3. If the power supply is interrupted, remove the battery and clean the plug contacts of the appliance.
4. If the motor protection switch has switched off the motor due to overload, wait until the motor protection switch enables the motor again.
How can I clear blockages of the cutting blade on the AL-KO SOLO HT 3645?
If material is blocking the cutting blade, follow these steps:
1. Switch off the AL-KO SOLO HT 3645 and remove the battery.
2. Clear the blockage, such as a branch.
3. Wait for around 5 seconds.
4. Insert the battery again and switch on the hedge trimmer.
How do I correctly install and remove the battery from the AL-KO SOLO HT 3645?
To install the battery, push the battery into the battery slot until it engages.
To remove the battery, press and hold the release button for the turning movement on the battery, then pull out the battery.
How can I operate the AL-KO SOLO HT 3645 in ECO mode?
The ECO mode function allows you to reduce the speed of the cutting blade, which prolongs the operating time of the battery.
1. Press the ECO mode button.
2. Press the button again to deactivate ECO mode.
If the appliance is switched off and then switched on again, it will start with the previously selected setting.
How do I turn the rear handle of the AL-KO SOLO HT 3645?
To turn the handle:
1. Pull the release button for the turning movement back.
2. Turn the handle to the left or right by 90° or 45° until it engages.
3. Release the button for the turning movement.
To turn the handle back, follow the same steps to return the handle to the initial position until it engages.
What maintenance is required for the AL-KO SOLO HT 3645 gearbox?
The gearbox should be lubricated after approximately 25 operating hours:
1. Unscrew the plug on the underside of the hedge trimmer from the filler neck.
2. If no grease is visible on the plug, push the grease tube into the filler neck.
3. Press up to 5 g of gearbox grease into the gearbox housing. Note: Do not fill the gearbox housing completely.
4. Screw the plug firmly back into the filler neck.
What are the technical specifications for the AL-KO SOLO HT 3645?
| Feature | AL-KO SOLO HT 3645 |
|---|---|
| Blade length | 450 mm |
| Cutting capacity (max) | 30 mm |
| Weight (without battery) | 3.6 kg |
| Speed (Power-Mode) | 5400 min-1 |
| Speed (ECO-Mode) | 4300 min-1 |
How should I store the AL-KO SOLO HT 3645 during long breaks in use?
Before any storage intervals lasting longer than 30 days, follow these steps:
1. Clean the cutting blade and spray it with anti-rust oil.
2. Thoroughly clean the appliance and store it in a dry, frost-protected room.
CLICK HERE TO DOWNLOAD AL-KO SOLO HT 3645 (01) PDF DOCUMENT