FREE ENGLISH BLADE GB200 (01) PDF USER GUIDE
FREE ENGLISH BLADE GB200 (01) PDF USER MANUAL
FREE ENGLISH BLADE GB200 (01) PDF OWNER GUIDE
FREE ENGLISH BLADE GB200 (01) PDF OWNER MANUAL
FREE ENGLISH BLADE GB200 (01) PDF REFERENCE GUIDE
FREE ENGLISH BLADE GB200 (01) PDF INSTRUCTION GUIDE
FREE ENGLISH BLADE GB200 (01) PDF REFERENCE MANUAL
FREE ENGLISH BLADE GB200 (01) PDF INSTRUCTION MANUAL
FREE ENGLISH BLADE GB200 (01) PDF OPERATING INSTRUCTIONS
CLICK HERE TO DOWNLOAD BLADE GB200 (01) PDF MANUAL
If this is not the document you want for this product, click here to see if we have any other documents for this product.
What is the general procedure to update the gimbal firmware for the Blade 350 QX?
To use the gimbal tilt control function with the Blade 350 QX quadcopters, you must update the gimbal firmware using the procedure below, install a Spektrum DSMX remote receiver to your gimbal and bind it to your radio during the bind procedure of the 350 QX.
How do I download the gimbal firmware update file?
Download the gimbal firmware update zip file.
What should I do after downloading the firmware update zip file?
Extract the files from the zip file.
How do I prepare the USB dongle for the firmware update?
Install the driver in the zip file for the USB dongle.
How do I connect the USB dongle to my computer?
Connect the USB dongle to a USB port on your computer. Ensure no other devices are connected to a USB port.
Where do I connect the USB dongle on the GB200 gimbal?
Connect the USB dongle to the Software Update Port (E) on your GB200 gimbal.
How do I start the firmware update process on my computer?
Open the Firmware Updater appropriate for your computer operating system.
Which file should I select in the Firmware Updater?
Select “Choose File” and select the GB200_RemoteRX.bin file in the folder.
Which COM option should I select in the Port dropdown menu?
Select the second COM option in the dropdown menu in Port. Do not select COM1.
What is the next step after selecting the COM option?
Select “Wait For Device and Upload Firmware.”
How do I power on the 350 QX during the update?
Connect a charged flight battery to the 350 QX and power it ON within 60 seconds.
What message will appear when the update is complete and what should I do?
When the update is complete, a screen will prompt: “Device was upgraded successfully. Please disconnect and reset device.” Select OK.
How do I finalize the firmware update process?
Power OFF the 350 QX and disconnect the dongle.
What should I do if the firmware update fails?
If the update fails, repeat the above procedure.
CLICK HERE TO DOWNLOAD BLADE GB200 (01) PDF MANUAL