BELKIN ULTRACHARGE WIZ039 (01) PDF Document

WARNING: Failure to follow these instructions could result in fire, electric shock, injury, or damage to the user, product, or other property.

1. Connect the power supply of the wireless charger into a power outlet that is close by and is easy to disconnect from the source.

2. Use indoors and in a dry location only; keep away from wet or damp locations.

3. Keep the wireless charger and power supply away from any liquids or moisture.

4. Unplug the wireless charger if unused for long periods of time.

5. Do not store your device in very high or very low-temperature environments.

6. Do not use if visible defects are observed on the wireless charger or power supply.

7. Do not attempt to service, modify, or disassemble the wireless charger or power supply.

8. Use of a power supply not recommended or sold by Belkin may result in an increased risk of fire, electric shock, injury, or damage to the user, product, or other property.

CAUTION: If you experience problems with the wireless charger, please discontinue use and unplug the power supply from the wall outlet.

This equipment complies with the radiation exposure limits for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.

We, Belkin International, Inc., of 555 S. Aviation Blvd, Suite 180, El Segundo, CA 90045, declare under our sole responsibility that the product WIZ039, 2-in-1 Foldable Magnetic Charger, to which this declaration relates, complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Federal Communications Commission Interference Statement:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the device.

Belkin International, Inc., declares that the radio equipment complies the Radio Equipment Directive 2014/53/EU, EP 2009/125/EC, 2011/65/EU and its amendment (EU) 2015/863, and REACH Regulation EC 1907/2006.

Band of frequency in which the radio equipment operates: 360kHz, 111-148kHz.

Maximum power transmitted: <-5 dBuA/m at 10 m.

Belkin International, Inc., declares that the radio equipment complies Radio Equipment Regulations 2017 No. 1206.

The symbol of the crossed-out wheeled bin indicates that this product must not be disposed of with other household waste.

Pursuant to and in accordance with Article 14 of the Directive 2012/19/EU of the European Parliament on waste in electrical and electronic equipment (WEEE):

1. The separate collection of this equipment from other types of waste is required.

2. This product must be collected separately from other wastes.

For this reason, all products that have reached the end of their useful life must be given to waste disposal centers specializing in separate collection of waste electrical and electronic equipment, or given back to the dealer when purchasing a new WEEE, pursuant to and in accordance with Article 14 as implemented in the country.