ASPIRE ZELOS M80 (01) PDF Document

To fill the ASPIRE ZELOS M80 Tank, follow these steps:

Step 1. Unscrew the top cap from the tank section.

Step 2. Fill the tank by dripping e-liquid into the side ports, avoiding the center airflow tube.

Step 3. Screw the top cap back onto the tank section securely.

To replace the coil in the ASPIRE ZELOS M80 Tank, follow these steps:

Step 1. Unscrew the top cap from the tank section.

Step 2. Unscrew the atomizer base from the tank section.

Step 3. Remove the used coil from the atomizer base.

Step 4. Insert a new coil into the atomizer base, ensuring it is seated correctly.

Step 5. Screw the atomizer base back onto the tank section.

Step 6. Screw the top cap back onto the tank section.

Step 7. Allow the new coil to saturate for a few minutes before using.

For optimal battery performance and safety with the ASPIRE ZELOS M80, observe the following charging recommendations:

Use only the original charger or a certified charger.

Do not leave the ASPIRE ZELOS M80 unattended while charging.

Do not use the ASPIRE ZELOS M80 while it is charging.

If damage is found to the USB port or battery components, immediately stop using the device and seek replacement parts.

For the ASPIRE ZELOS M80, if damage occurs to the battery or if the battery stops holding a charge, the following procedure is recommended:

The manufacturer is responsible for any malfunction arising from the use of non original charger, battery, components, and accessories.

You must replace the battery if you suspect damage to ensure safe operation.

If the battery is damaged or leaking, immediately stop using the device and dispose of it properly.

To avoid losing the battery capacity on your ASPIRE ZELOS M80, keep it away from extreme temperatures and never leave it in a hot place, like inside a car.

Observe the following safety precautions when operating the ASPIRE ZELOS M80:

Do not attempt to disassemble the battery or tank, as this may cause damage or personal injury.

Use only approved accessories and replacement parts from the original manufacturer.

Do not use the device if the e-liquid is leaking.

Keep the ASPIRE ZELOS M80 out of reach of children and pets.

Do not expose the ASPIRE ZELOS M80 to extreme temperatures.

If you suspect damage to any device component, cease use immediately.

Regarding the disposal of the ASPIRE ZELOS M80, adhere to the following:

Do not dispose of the ASPIRE ZELOS M80 with regular household waste.

Take electronic waste to designated collection points for proper recycling.

The charging specifications for the ASPIRE ZELOS M80 are detailed in the following table:

The specifications for the ASPIRE ZELOS M80 Tank components are outlined in the table below:

The wattage output range for the ASPIRE ZELOS M80 is as follows:

To prime a new coil for the ASPIRE ZELOS M80 Tank before first use:

Step 1. Unscrew the top cap and atomizer base.

Step 2. Screw the new coil into the atomizer base.

Step 3. Insert the coil into the tank section.

Step 4. Fill the tank with e-liquid, ensuring the liquid covers the cotton wicking ports on the coil.

Step 5. Screw the atomizer base and top cap back onto the tank.

Step 6. Allow the coil to saturate for at least 5 minutes before taking a puff. Do not fire the device until the coil is saturated.

The ASPIRE ZELOS M80 typically indicates the battery level via an indicator light next to the fire button. The color or flashing pattern of this light corresponds to the remaining charge:

Green light usually indicates a high battery charge.

Yellow light usually indicates a medium battery charge.

Red light usually indicates a low battery charge requiring immediate attention.