FREE ENGLISH AMERICAN DJ S-100A (01) PDF USER GUIDE
FREE ENGLISH AMERICAN DJ S-100A (01) PDF USER MANUAL
FREE ENGLISH AMERICAN DJ S-100A (01) PDF OWNER GUIDE
FREE ENGLISH AMERICAN DJ S-100A (01) PDF OWNER MANUAL
FREE ENGLISH AMERICAN DJ S-100A (01) PDF REFERENCE GUIDE
FREE ENGLISH AMERICAN DJ S-100A (01) PDF INSTRUCTION GUIDE
FREE ENGLISH AMERICAN DJ S-100A (01) PDF REFERENCE MANUAL
FREE ENGLISH AMERICAN DJ S-100A (01) PDF INSTRUCTION MANUAL
FREE ENGLISH AMERICAN DJ S-100A (01) PDF OPERATING INSTRUCTIONS
CLICK HERE TO DOWNLOAD AMERICAN DJ S-100A (01) PDF MANUAL
If this is not the document you want for this product, click here to see if we have any other documents for this product.
What safety precautions should be taken before replacing lamps or servicing the unit?
Always disconnect from main power before replacing lamps or servicing unit.
Remember to always replace with same lamps and fuses.
What are the specifications of the S-100A™ Strobe?
| Lamp: | ZB-45 |
| Power: | 110V/60Hz |
| Working Position: | Any |
| Weight: | 7 lbs. |
| Size: | 9″ x 9″ x 9″ |
How do I operate the S-100A™ Strobe?
Unit is ready to be hung or set on the ground.
After plugging in unit, the light can be controlled by the strobe flash adjustment pot on the rear of the strobe.
The S-100A™ is a 45W strobe, including mounting bracket and control signal input and output for linking up to four S-100A’s.
For use with the S-10A™, S-4A™, or the S-2A™ remote controls.
To link strobes use a 1/4″ to 1/4″ mono cable.
How do I replace the lamp in the S-100A™ Strobe?
Unplug unit.
Unscrew front two screws and remove front plastic.
Take out lamp, replace with a new lamp, then reassemble.
Do not take the metal housing apart, strobes retain HIGH VOLTAGE inside.
There are no serviceable parts inside.
CLICK HERE TO DOWNLOAD AMERICAN DJ S-100A (01) PDF MANUAL