ADLER AD 7342 (01) PDF Document

Before using your ADLER AD 7342 fan for the first time, the battery must be fully charged. Only use the supplied USB charging cable, which has an A connector and a type C plug.

To charge your ADLER AD 7342 fan, follow these steps:

1. Before charging, check and make sure the power source is compatible with the device.

2. Take the provided power cord and plug it into the USB Type-C outlet on the fan.

3. During charging, the LED indicator will flash red. When the battery is fully charged, the LED indicator will light up red continuously.

To operate your ADLER AD 7342 fan, use the on/off and fan speed button:

First press: Turns the device on and sets a low airflow speed.

Second press: Sets a medium airflow speed.

Third press: Sets a high airflow speed.

Fourth press: Turns the unit off.

The ADLER AD 7342 fan consists of the following parts:

1. On/off and fan speed button

2. Housing

3. USB type C socket

4. Propeller

6. USB connector (A connector and type C plug)

7. LED indicator

8. Mounting clamp / stand

If water is spilled on the surface of the ADLER AD 7342, unplug the device and let it dry for 24 hours. After it is completely dry, you can use it as usual.

Improper use of the built-in rechargeable batteries in the ADLER AD 7342 may cause electrolyte leakage, overheating, or explosion. To reduce the risk of injury:

• Batteries should not be heated, opened, punctured, destroyed, or thrown into a fire.

• Do not touch the battery terminals in the device with metal objects. These components can become hot and cause burns.

• In case of battery leakage, avoid contact of leaking electrolyte with skin or clothing. If battery electrolyte comes into contact with skin or clothing, immediately flush the area with water.

• Charge only with the charger supplied with the product, or one suitable for the battery type.

The chemical composition of the built-in battery used is lithium.

Please follow these safety and operational instructions when using your ADLER AD 7342 fan:

• Do not use the product for purposes incompatible with its use.

• Never place the product near hot or warm surfaces or kitchen appliances, such as an electric oven or gas burner.

• Never use the product near combustible materials.

• Do not place the device near open flames or fire sources.

• It is recommended to use the fan only in a dry place.

• Do not expose the device to direct sunlight for a long time.

• Use only the original USB cable provided in the package.

• Unplug the device when cleaning or moving it.

• For best results, place the device on a higher surface, such as a table or countertop.

• Do not allow foreign objects to get inside the device.

• Do not block the front and rear grilles of the device.

• Do not cover the device.

• Do not immerse the device under water or in other liquids.

• Be aware that rotating parts may pull out loose clothing and hair.

USB POWER INPUT: 5V 1A

BATTERY: 3.7V 3000mAh; battery: lithium battery

POWER: 5W

Dimensions: 200×125×280mm