ADAM HALL SLT001 (01) PDF MANUAL

ADAM HALL SLT001 (01) PDF SUMMARY:

How do you assemble the upper and lower supports?

Take one of the upper supports and place it over the outside of one of the lower supports. Align the upper support holes with the lower support mounting holes to obtain the desired height. Place one knob at a time through the mounting holes, ensuring they are spaced at least 2 holes apart.

How do you install the stabilizer bar?

Take a stabilizer bar and screw the top knob into the end of the stabilizer bar. Repeat with bottom knob.

How do you increase the stand width?

Install 1-inch spacers on each stabilizer bar to increase the stand width.

What should you do after you assemble the upper and lower supports?

Repeat the assembly process with the other upper support and lower support for the opposite side of the stand. Secure all knobs tightly to minimize stand wobble.

How do you assemble the table top?

Attach the flat foot bar to the lower support with four A-screws and washers. Repeat this process with the other lower support for the opposite side of the stand.

How do you assemble the table with C-clamps?

Turn the clamp with the knobs facing down and attach it to the lower support using two B-screws and B-washers. Repeat with the other lower support for the opposite side of the stand.

How do you assemble the DJ coffin with C-clamps?

Turn the clamp with the knobs facing the back of the stand and attach it to the lower support with two B-screws and B-washers. Repeat with the other lower support for the opposite side of the stand.