A4TECH FSTYLER BH230 (01) PDF Document

The box for the A4TECH FSTYLER BH230 includes the following:

• Bluetooth Headset
• USB Type-C Rechargeable Cable
• User Manual

The buttons on the A4TECH FSTYLER BH230 control several functions:

• Volume + / Next Track: Short Press increases volume, Long Press skips to the Next Track.
• Volume – / Previous Track: Short Press decreases volume, Long Press skips to the Previous Track.
• Power Switch: Used to turn the device On or Off.
• Play/Pause: Used for music playback control.
• Microphone Mute: Used to mute or unmute the microphone.

To enter pairing mode on the A4TECH FSTYLER BH230:

Turn On: Long press the power button for 2 seconds to enter pairing mode, the indicator light flashes in red and blue alternately.

To turn off the A4TECH FSTYLER BH230:

Turn Off: Long press the power button for 5 seconds, the indicator light turns off.

Music Playback and Call control on the A4TECH FSTYLER BH230 is managed as follows:

• Music Playback: Short Press the Play/Pause button to Play/Pause music.
• Incoming Call: Short Press the Play/Pause button to Answer or Hang-up a call.

To mute or unmute the microphone on the A4TECH FSTYLER BH230:

• Microphone Mute: Double-touch to turn on or off the microphone.
• Turn On Mic. results in a “Mute Off” sound.
• Turn Off Mic. results in a “Mute On” sound.

To connect the A4TECH FSTYLER BH230 for the first time:

Step 1. Long press the power button for 2 seconds, the indicator light flashes in red and blue alternately when pairing.

Step 2. Choose “A4TECH BH230” from your Bluetooth device list.

Step 3. The indicator flashes in Blue slowly after the headset is connected.

For the second time use of the A4TECH FSTYLER BH230:

The device you connected last time will be remembered. It will automatically connect back to the last device after power on.

Warm Tips: Make sure the Bluetooth device is turned on.

The indicator light during charging for the A4TECH FSTYLER BH230 indicates the following:

• Solid Red Light: Charging
• Light Off: Fully Charged

A flashing red light indicates when the battery is below 25%.

The charging time and playback time for the A4TECH FSTYLER BH230 are:

• Charging Time: 1.5H (1.5 Hours) results in approximately 15 minutes of charging providing about 3 hours of playback time. The total 1.5H Charging Time provides 55 Hours Playback Time (at 50% volume).

The technical specifications for the A4TECH FSTYLER BH230 are:

The safety rules for the A4TECH FSTYLER BH230 are:

1. To avoid hearing damage, do not use headphones at a high volume for a long time.
2. Never disassemble or modify your headphones for any reason. Otherwise, it may cause the headphones to malfunction, which is not covered by the warranty.
3. Do not get the device wet with liquids, otherwise will cause serious damage to the device. Damage caused by water entering the device will not be covered by the manufacturer’s warranty.
4. Please do not place the product in an environment where the temperature is too high or too low (above 45°C or below -20°C).
5. Not suitable for children under 3 years old.
6. Do not use the device during a thunderstorm.

The warning statements regarding the battery in the A4TECH FSTYLER BH230 are:

• To disassemble, bump, crush, or throw into the fire is forbidden for lithium batteries.
• Do not expose under the strong sunlight.
• The discard of the battery should obey the local law, if possible please recycle it. Do not dispose of it as household garbage, because it may cause an explosion.
• Do not continue to use if severe swelling occurs.
• Please try to avoid charging in an environment below 0°C.
• The user is not allowed to remove or replace the batteries unless specified statement in the user manual.

The A4TECH FSTYLER BH230 features a Flat Foldable design for portability.

The A4TECH FSTYLER BH230 uses Bluetooth v5.3.