Post questions, comments, reviews or page errors in the comment box below.

Click here to download 100 PERCENT PB7200 (01) PDF MANUAL


PDF Content Summary:

****** Page 1 ****** 11 ooo PERCENT Power Pack User Guide Location of Controls 6 @ 00 1. Flashlight 5 In the box 11 Micro USB Cable Specifications PB7200 Power Pack ooo- PERCENT Power Pack User Guide User Guide 2. USB output charging port (2.0A) for charging any device, including tablets, smartphones, etc. 3. Micro USB input charging port – for charging the Power Pack 4. USB output charging port (1 .OA) – for charging small devices such as smartphones 5. button: Power/flashlight ON/OFF Power capacity check 6. LED Power level status lights Charging the Power Pack To charge the Power Pack: 1. Connect the small end of the included Micro USB cable to the USB input charging port on the Power Pack. 2. Connect the large end of the included Micro USB cable to an available USB port on your computer or an AC power adapter (not included). 3. The LED power level status lights will light up while the Power Pack is charging. 4. The LED power level status lights will all light up BLUE when fully charged (approx. 6-8 hours). 5. When done charging, remove the cable from the ports. Checking the capacity of the Power Pack: Press the [(1)1 button to check the power capacity. The power level status LEDs will light up according to available power capacity. 0000 0000 0000 0000 25-50% capacity 50-75% caoacity The output I.OA port is suitable for charging small devices such as smartphones. The output 2.0A port is suitable for charging any device, including tablets, smartphones, etc. To charge 2 devices with the Power Pack: If you are trying to charge 2 devices at the same time, the devices you are charging must both have over 30% capacity. If you have 2 devices plugged into the Power Pack and the devices are not charging, then follow these steps: 1. Unplug both devices from the Power Pack. 2. Plug the Power Pack back into a charging source for ten seconds or more to restart it. 3. Charge 1 device at a time. 4. Once both devices are over 30% capacity you can charge them at the same time. NOTE: Some newer smartphones require the charging Amerpage of tablets. If the Power Pack will not charge 2 devices each time you try, then repeat steps 1-3 above and always charge them one at a time. Activating the LED Flashlight 1. Press the [ d)) button once to activate the LED Power level status lights. 2. Press [(51 again to activate the LED Flashlight. 3. Press [(51 to shut the LED Flashlight off. Charging the Power Pack MICRO USB INPUT CHARGING PORT pc Legal Caution: Any changes or modifications not expressly approved could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installatiom This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular Installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna, • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. ecycze R BRC Li-ion 8229 100 Percent is a registered trademark of Southern Telecom, Inc. Manufactured, marketed, and distributed by Southern Telecom, Inc., Brooklyn, N, Y, 11232 02015 Southern Telecom, Inc. All rights reserved. Toll-free customer service: 1-877-768-8481 , Monday- Friday 8 a.m.- 10 p.m. (EST) Customer service online: southerntelecom.com; click on ” Product Support.” Made in China I Designed in the U.S.A. Charging Other Devices o = 00 Limited Warranty 0 o USB OUTPUT CHARGING PORT 75%capacity Capacity: Input: Output 1: Output 2: 7200mAh DC 5V 800mA DC 5V 1 OOOmA DC 2000mA To charge devices with the Power Pack: 1. Connect the USB end of your device’s charging cable to either output port on the Power Pack. One output port delivers 1 .OA, the other port delivers 2.0A. 2. Connect the other end of your device’s charging cable to your device’s charging port (please refer to your device’s user guide for charging instructions). You can charge up to two devices at the same time. 3. Use your device’s battery indicator to determine when the device is fully charged. 4. When your device is fully charged, remove the cable from the ports. NOTE: If the device you are charging draws too much power from the Power Pack, it will stop charging and go into standby mode. If this happens, unplug the device from the Power Pack, then recharge the Power Pack to get it back into charging mode. This product as supplied and distributed new by AIT, Inc. CAIT$’) to the original consumer purchaser is warranted by AIT aaainst defects in material and workmanship for a period of one year Trom your date of purchase (“Warrantv”). In the unlikely event that this prcxiuct is defective, or does not perform properly, you may within one year from your original date of purchase return it to the authorized service center for repair or exchange, TO OBTAIN WARRANTY SERVICE: • Call the Customer Support number located below, or go to our website ponal to receive an SRO number. • Provide proof of the date of purchase within the package (Dated bill of sale). • Prepay all shipping costs to the authorized service center, and remember to insure your return. • Include a return shipping address (no P.O. Boxes). a telephone contact number, and the defective unit within the package. • Describe the defect or reason you are returning the product, Your product will be repaired or replaced, at our option, for the same or similar model of equal value if examination by the serv:ce center determines this product is defective. Products received damaged as a result of shipping will require you to file a claim with the carrier. The shipping address of the authorized service center is: AIT Inc. ATMN: Customer Service (2nd Floor) 14-C 53rd Street Brooklyn, NY 11232 IN NO EVENT WILL AIT ITS MANUFACTURERS. DISTRIBUTORS OR PLR IP HOLDINGS LLC BE LIAéLE FOR ANY INCIDENTAL, DIRECT INDIRECT SPECIAL PUNITIVE ÖR CONSEQUENTIAL DAMAGES (SUCH AS BUT NOT LIMITEDTO DAMAGES FOR LOSS OF PROFITS BUSINESS SAVINGS DATA OR RECORDS} RELATEDTOTHIS PRODUCT. EXCEPT AS StATED HÉREIN, NO OTHER WARRANTIES SHALL APPLY


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE – USER MANUAL

OWNER GUIDE – OWNER MANUAL

REFERENCE GUIDE – REFERENCE MANUAL

INSTRUCTION GUIDE – INSTRUCTION MANUAL

100 PERCENT PB7200 (01) PDF MANUAL

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.