YENKEE YMS 3002 (01) PDF Document

The main components of the YENKEE YMS 3002 are:

1. Left button

2. Right button

3. Scrolling wheel

4. Top button (DPI)

5. Front side button (navigate forward)

6. Rear side button (navigate backward)

7. Connection mode switch

To connect your YENKEE YMS 3002 using the 2.4G receiver, follow these steps:

1. Connect the supplied cable to the docking USB receiver, then connect the other end to the USB socket on your PC.

2. Set the connection mode switch (7) on the bottom of the mouse to the bottom position to put the mouse in 2.4G mode.

3. The mouse will connect to the receiver and should work immediately.

4. Wait until your operating system detects the mouse and automatically installs the necessary drivers for proper functionality.

5. After your operating system displays a message confirming successful installation, you can use the mouse freely.

To establish a Bluetooth connection with your YENKEE YMS 3002, please follow these instructions:

1. Set the connection mode switch (7) to the top position to put the mouse in BT mode. The mouse will start flashing blue.

2. Hold down the upper DPI button (4) for about 3 seconds. The mouse will start flashing much faster, which indicates that pairing mode is activated.

3. Enable Bluetooth device searching on your device, pair it with the mouse, and you can start using it immediately.

To use the YENKEE YMS 3002 as a wired mouse:

1. Set the connection mode switch (7) to the central OFF position to turn off the mouse’s wireless connection.

2. Connect the attached cable to the USB-C socket on the front of the mouse.

3. Connect the other USB-A end of the cable to the relevant socket on your device.

4. Wait until your operating system detects the mouse and automatically installs the necessary drivers for proper functionality.

5. After your operating system displays a message confirming successful installation, you can use the mouse freely.

The docking receiver for the YENKEE YMS 3002 is also equipped with a removable cover that has an adhesive area on the bottom. This allows it to be attached to a table or installed vertically onto a table side panel or a wall.

This feature allows you to simply remove the receiver from the cover and take it with you when moving or traveling, while still having the receiver’s base fixed in its usual location exactly where you want it to be.

To use all mouse functions, you need to install the control program. Follow these steps:

1. Download the program.

2. Wait for the download to finish and open the file.

3. Double-click the executable .exe file to start the installer.

4. Follow the on-screen instructions to complete the installation.

5. Run the program.

The system requirements for the YENKEE YMS 3002 are:

• USB port

• Windows 7/8/10/11

Instructions and information regarding the disposal of used packaging materials:

Dispose of packaging material at a public waste disposal site.

Disposal of used electrical and electronic appliances:

The meaning of the symbol on the product, its accessory, or packaging indicates that this product shall not be treated as household waste. Please dispose of this product at your applicable collection point for the recycling of electrical & electronic equipment waste. Alternatively, in some states of the European Union or other European states, you may return your products to your local retailer when buying an equivalent new product.

The correct disposal of this product will help save valuable natural resources and help in preventing the potential negative impact on the environment and human health, which could be caused as a result of improper liquidation of waste. Please ask your local authorities or the nearest waste collection center for further details. The improper disposal of this type of waste may fall subject to national regulations for fines.