XTRA EDGE PRO (01) PDF Document

To attach the battery, press the release button on the battery compartment cover and slide upward. Then, lift off the cover and insert the battery.

To charge the camera, press the release button on the USB-C port cover and slide downward. Then, lift off the cover and connect a USB-C charger to the USB-C port using the provided cable.

Press and hold the Quick Switch button to power the camera on or off.

The camera has built-in storage. If you need extra storage space, open the battery compartment cover and insert a UHS-I U3-rated microSD card.

Press the Shutter/Record button to take a photo or start/stop recording.

During video and slow-motion recording, press the Quick Switch button once to mark a highlight moment in the footage.

Press and hold the Shutter/Record button to power on quickly and begin shooting. Press the Shutter/Record button again to stop recording. The camera will automatically power off if left idle for three seconds.

1. Storage Capacity/Remaining Recording Time

2. Battery Level

3. Current Shooting Mode: Tap the icon or swipe left or right in the center of the screen to change shooting modes.

4. Zoom: Tap and hold to set the zoom ratio.

5. Primary Settings: Tap to change the primary settings for the current shooting mode.

6. Advanced Settings: Tap to fine-tune image and audio parameters.

7. Playback: Tap to see the last video or photo you took.

Tap to change the primary settings for the current shooting mode. Taking the Video mode as an example:

Top left corner: Video recording options, including pre-recording and loop recording.

Top right corner: Stabilization and FOV options.

In the middle: Resolution, aspect ratio, and frame rate.

Notice: Available settings vary according to the shooting mode.

Tap the Playback icon to see the last video or photo you took. Swipe left from the right edge of the touchscreen to exit playback.

Swipe down from the top of the screen to access the Control Center. The Control Center allows you to quickly change settings and enable/disable features such as Quick Switch, Custom Modes, Brightness, General Settings, Full Front Screen, Voice Control, Screen Lock, and Orientation Lock.

Swipe down from the top of the screen, then swipe left to access the storage management screen. If a microSD card is used, you can switch to SD card storage.

Tap the right box to format the internal storage or the microSD card.

CAUTION: Formatting will permanently delete all data. Make sure to back up all required data before formatting.

1. Attach and press down the mount firmly on a clean curved surface, and hold for at least 10 seconds. Wait 30 minutes before attaching the camera. The recommended application temperature is -10° to 40°C (14° to 104° F).

2. Press down on the camera until the clips of the mount adapter are firmly inserted into the quick-release slots on the camera.

3. Secure the assembly using the screw.

1. Lift the clip on the top of the frame and insert the camera into the frame.

2. Push down the clip to secure the camera in place.

3. Secure the assembly using the screw.

Press the Quick Switch button once to scroll through shooting modes.

1. Download the Xtra app.

2. Enable Wi-Fi and Bluetooth on the mobile device. Launch the app and tap the camera icon on the home screen.

3. Follow the on-screen instructions to connect your camera to the app.

Once connected to the app, you can view, edit, and share your videos and photos. Tap the playback icon to preview photos and videos. Tap the download icon to download photos and videos.

1. Power on the camera and connect it to a computer using the provided cable.

2. When connected to a computer, a pop-up will appear on the camera.

3. Tap the file transfer option to download the files from the camera to the computer.

Notice: When transferring a file, the camera cannot take photos or record videos.

When connected to the camera, the Xtra app will notify you if new firmware is available. Tap the prompt and follow the on-screen instructions to update the firmware.