WAHL 9685 (01) PDF MANUAL

Your kit contents may vary from that shown.

1. To attach a comb, hold it with the teeth up. Hook the front edge of the comb attachment firmly to the bottom of the blade.

2. Push down on the back of the comb until it snaps into place.

3. To remove the comb, firmly lift up on the release tab on the back of the attachment comb.

Attach the adjustable guide comb in the same manner as individual guide combs. Adjust the cutting length by moving the thumb lever (for 5-position and 6-position combs) or rotating the dial (for 10-position combs) to the desired position indicated on the comb. The available lengths depend on the specific adjustable comb included in your kit:

5-Position Comb Lengths: 2 mm, 5 mm, 7 mm, 10 mm, 12 mm

5-Position Low Profile Comb Lengths: 3 mm, 6 mm, 10 mm, 13 mm, 16 mm

6-Position Comb Lengths: 2 mm, 4 mm, 6 mm, 8 mm, 10 mm, 12 mm

10-Position Comb Lengths: 2 mm, 3 mm, 4 mm, 5 mm, 6 mm, 7 mm, 8 mm, 9 mm, 10 mm

Your kit may include some or all of the following individual guide combs:

Guide Comb I: 1.6 mm

Guide Comb II: 3.2 mm

Guide Comb III: 4.8 mm

Guide Comb #1: 3 mm

Guide Comb #2: 6 mm

Guide Comb #3: 10 mm

Guide Comb #4: 13 mm

Guide Comb #5: 16 mm

Guide Comb #6: 19 mm

Guide Comb #7: 22 mm

Guide Comb #8: 25 mm

Remember, your kit contents may vary.

Connect the charging transformer cord to the trimmer. Be sure the trimmer is OFF when charging. Plug the charging transformer into a convenient electrical outlet at the correct voltage.

A full charge takes approximately 12 hours. A fully charged trimmer provides up to 80 minutes of cordless runtime.

Place a few drops of Wahl Clipper Oil on the blades before and after each use. For best results, put three drops on the front of the blade and one drop on each side of the blade. Use only Wahl Clipper Oil.

1. Ensure the trimmer is OFF and unplugged.

2. Gently push the blade set away from the front of the trimmer housing.

3. Use the provided cleaning brush to remove hair clippings from the blade set and from the trimmer body (especially the area under the blade).

4. To reattach the blade set, hook the bottom tab of the blade chassis into the housing and snap the top of the blade set onto the housing.

Yes, this trimmer features an electronic travel lock to prevent accidental activation. To activate or deactivate the travel lock, press and hold the power button for 10 seconds.

Before discarding the trimmer, the battery must be removed. Follow these steps:

1. Ensure the trimmer is unplugged from the charger.

2. Turn the trimmer ON and run the battery down completely before disassembly.

3. Pry open the trimmer housing.

4. Disconnect or cut the wires leading to the battery pack.

5. Remove the battery pack from the trimmer housing.

6. Dispose of the battery properly according to your local regulations. Do not incinerate or dispose of in general waste.