VISSLES MS1 (01) PDF MANUAL

The product includes several components with distinct features:

Extendable clip:

• Both ends can be folded inward.
• The inner side of the clip is 13.5-26CM, designed for mobile phones or tablets with a screen size of 5-15.5 inches.

Tablet Stand:

• Aluminum alloy base: The maximum opening angle is 90°.
• Hinge structure (B): After removing the spindle cap, the hexagonal screw can be reinforced with a Hex key; it supports a rotation angle of 200°.
• Hinge structure (C): After removing the spindle cap, the hexagonal screw can be reinforced with a Hex key; it supports a rotation angle of 360°.
• Universal joint: The tilt angle of the clip is 50°, and the parallel rotation angle of the clip is 250°.

Tablet Mount Base:

• It has a screw hole.
• The base features a 3M adhesive pad.

Allen Wrench and screws:

• The inner hex key is used to reinforce the hinge structure.
• Screws can be used to fix the tablet mount base.

To connect the tablet stand and extendable clip, follow these steps:

1. Place the fixing ring on the universal head.

2. Align the universal head with the threaded structure on the back of the clip, and press firmly until the universal head enters the threaded structure.

3. Tighten the fixing ring.

To use the tablet mount base, follow these steps:

1. Clean the surface where the bracket will be fixed; it should be a flat surface such as a wall or the surface of a cabinet.

2. Tear off the protective film on the 3M adhesive pad and stick the tablet mount base on a flat surface.

3. Use the screws provided to pass through the screw holes to fix the tablet mount base on the flat surface.

4. Make sure the base is fixed firmly to prevent your device from falling from the base.

To fasten the hinge, follow these steps:

1. Remove the silicone cap on the hinge.

2. Use the inner Hex key to tighten the hexagonal screws at the hinge.

To place your device in the extendable clip:

1. The clip can be extended with a length ranging from 13.5cm to 26cm. Please use a device within this size.

2. If the size of your device exceeds this range, please pull inward the clip on one side and place the stand vertical to the desktop, then place your device in the center.

For the most ideal and comfortable viewing angle, the product features multi-angle plus three-dimensional space adaptability, allowing users to make appropriate adjustments according to their own needs.

If you have a large device, please slowly adjust the angle and height as needed to prevent your device from falling due to the center of gravity deviation.

The technical specifications are as follows:

Brand: Vissles

Product Name: Vissles 2-in-1 Mount Stand

Model: Vissles-MS1

Material: Aluminum alloy, ABS, Silica gel

Color: Black

Weight: 0.426KG (Tablet Stand) + 0.076KG (Tablet Mount Base) + 0.013KG (Allen Wrench and Screws)

Load-bearing: Up to 2KG

Dimension: 241*80*52mm (Folded)/270*321*180mm (Extended)

Compatibility: It is recommended for 5-15.5 inch mobile phones or tablets.