VELLO PGS-P (01) PDF Document

Please follow these precautions when using your VELLO PGS-P:

• Please read and follow these instructions, and keep this manual in a safe place.

• Make sure that this product is intact and that there are no missing parts.

• Make sure that all connections and attachments are secure before proceeding.

• All images are for illustrative purposes only.

The VELLO PGS-P is composed of the following parts:

1. Hand strap

2. Top strap

3. Detachable security strap

4. Bottom strap

5. Arca-style baseplate

6. 1/4-20 mounting screw

7. Eyelet release button

8. Eyelet

Follow these steps to attach and fit the VELLO PGS-P:

1. Screw the baseplate into the camera’s tripod socket so the eyelet doesn’t cover the battery compartment.

2. Thread the top strap up through the camera lug on the trigger side.

3. Thread the top strap through the loop and the buckle, and tuck the end of the strap into the pocket.

4. Put your hand through the strap. The strap should fit snugly around your hand. To tighten the strap around your hand, shorten the bottom strap.

5. Wrap the security strap around the inside of your wrist.

6. Adjust the strap’s length until it fits snugly around your wrist.

To mount the VELLO PGS-P onto a tripod or head, follow these instructions:

1. Loosen your tripod head’s Arca-style clamp, and insert the baseplate.

2. Support your camera with one hand while you balance the camera, and tighten the Arca clamp until secure.

Important! If the eyelet is not flush against the bottom of the camera, it will not fit into the clamp. Press the eyelet release button, and fold it up against the camera’s base.

You can carry your camera on a shoulder strap, so it hangs upside down at your hip with or without the hand strap. To attach a shoulder or cross-body strap:

1. Press the eyelet release button, and fold the eyelet down until it snaps into place.

2. Attach the shoulder strap to the eyelet, and adjust the strap to the desired length.