ULTIMATE HEALTHCARE UBAS0022 (01) PDF Document

When using the ULTIMATE HEALTHCARE UBAS0022, please adhere to the following warnings:

• Ensure these instructions are fully read and implemented. Failure to do so may result in injury. Keep these instructions in a safe place for future reference.

• The maximum user weight of 25st 160kg should not be exceeded.

• Do not attempt to stand or climb on the product.

To adjust the height of the ULTIMATE HEALTHCARE UBAS0022 shower stool, follow these steps:

(a) Remove the ‘e-clip’ and slide the leg to the desired position.

(b) Align the holes and re-insert the ‘e-clip’.

(c) Repeat step (a) and (b) for all four legs.

Please note the following:

• If any parts appear damaged do not use and contact your supplier immediately.

• Ensure all legs are set at an equal height to avoid instability.

Clean the ULTIMATE HEALTHCARE UBAS0022 regularly using a general purpose, neutral detergent and warm water.

To disinfect the shower stool, wipe with a dilute bleach solution and rinse thoroughly with fresh water.

Always allow the product to dry fully prior to use or storage.

CAUTION: Check the suitability of the cleaning products before use.

WARNING: Abrasive cleaners or cloths should not be used as these could permanently damage the surface and invalidate any warranty.

For proper maintenance of your ULTIMATE HEALTHCARE UBAS0022 shower stool:

• Check that all ‘e-clips’ are inserted correctly and that there is no excessive movement.

• Inspect the product regularly for signs of wear or damage, paying particular attention to the condition of the ferrules.

• Any suspected faults or damage should immediately be reported to the supplier and the product taken out of use.

The ULTIMATE HEALTHCARE UBAS0022 should be thoroughly cleaned prior to disposal.