TWELVE SOUTH AIRFLY SE (01) PDF DOCUMENT

1. Turn the TWELVE SOUTH AIRFLY SE on by sliding the ON/OFF switch up. The device will automatically enter Pairing Mode the first time it is turned on, indicated by a flashing white and amber light. For the easiest pairing, turn off Bluetooth on the device you were previously using with your AirPods.

2. To enter Pairing Mode on your AirPods, first place the AirPods inside the Charging Case. With the lid open, press and hold the button on the back of the Charging Case until the light flashes white.

3. Once successfully paired, the light on the AirPods Charging Case will turn green, and the light on the AirFly SE will turn solid white and then turn off after 10 seconds. Initial pairing can take up to 90 seconds, but the AirFly SE will remember your AirPods for future reconnections.

4. Plug the TWELVE SOUTH AIRFLY SE into any device with a standard headphone jack to listen to audio wirelessly.

1. Turn the TWELVE SOUTH AIRFLY SE on by sliding the ON/OFF switch up. It will automatically go into Pairing Mode the first time it is turned on, indicated by a flashing white and amber light. For easier pairing, turn off Bluetooth on the device you were previously using with your headphones.

2. Put your headphones into Bluetooth Pairing Mode. Please refer to your headphones’ owner’s manual for specific instructions.

3. Once successfully paired, the light on the TWELVE SOUTH AIRFLY SE will be solid white and turn off after 10 seconds. Initial pairing can take up to 90 seconds, but the device will remember your headphones for future reconnections.

To adjust the volume, press the Volume Buttons (up “+” or down “-“). You can also press and hold the Volume Buttons to gradually increase or decrease the volume until its upper or lower limit is reached.

To mute the audio temporarily, double-click the Volume Down Button. The light will blink amber continuously to indicate that the volume is muted.

To unmute the audio, double-click the Volume Down button again. This will return the audio to its previous volume setting.

To check the battery status of the TWELVE SOUTH AIRFLY SE, double-click the Volume Up button (+). The number of amber blinks indicates the approximate battery level:

– 4 amber blinks = approximately 100%

– 3 amber blinks = approximately 75%

– 2 amber blinks = approximately 50%

– 1 amber blink = approximately 25%

Use the switch on the side of the TWELVE SOUTH AIRFLY SE to turn it on or off.

Slide the switch up to turn it on.

Slide the switch down to turn it off.

The AirFly SE will automatically reconnect to your headphones when it is turned back on.

To switch back to using your AirPods or headphones with your smartphone or tablet, first turn the TWELVE SOUTH AIRFLY SE off.

On your smartphone or tablet, open Bluetooth Settings and select your headphones from the list. The status should change from “Not Connected” to “Connected” once your headphones are successfully paired with your device.

To charge the TWELVE SOUTH AIRFLY SE, plug the included USB-C to USB-A Charging Cable into the AirFly SE, and then into any powered USB port. The device is fully charged within 2 hours. The internal battery lasts about 20 hours.

If your AirFly SE is low on power, it will flash amber 3 times to alert you that it needs to be charged soon.

While charging, the device will illuminate in solid amber. Once fully charged, the amber light will turn off. The TWELVE SOUTH AIRFLY SE can remain plugged in and charging while in use if desired.

If only one AirPod seems to be playing audio, turn the TWELVE SOUTH AIRFLY SE off and back on. This action will re-sync the device and should reconnect both AirPods.

To reset the TWELVE SOUTH AIRFLY SE, press and hold the Reset button on the side of the device for 4 seconds. Once reset, the AirFly SE will blink amber 4 times and then will automatically go into Pairing Mode.

– Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;

– Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;

– A battery subjected to extremely low air pressure that may result in an explosion or the leakage.