TINECO PURE ONE S70 (01) PDF Document

When using your TINECO PURE ONE S70, basic precautions should always be followed to reduce the risk of fire, electric shock, or injury:

1. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children should not play with the appliance. Cleaning and user maintenance shall not be performed by children without supervision.

2. The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.

3. For INDOOR use ONLY. Do not use the appliance in outdoors, nor in commercial or industrial environments. Do not use the appliance on wet surfaces or surfaces with standing water.

4. Do not allow to be used as a toy. Close attention is necessary when used by or near children, pets or plants.

5. Use only as described in this manual. Use only manufacturer’s recommended attachments.

6. Do not use with a damaged cord or plug. If appliance has been dropped, damaged, left outdoors, dropped into water, or is not working as it should, return it to a service center.

7. Do not handle charger, including charger plug, and charger terminals with wet hands.

8. Do not block openings. Stop use if openings become blocked. Clean and remove any blocked objects according to the manual instructions.

9. Keep hair, loose clothing, fingers, and all parts of your body away from openings and moving parts.

10. Use extra care when cleaning on stairs.

11. Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.

12. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.

13. Do not use without dust container and filter.

14. Prevent unintentional activation. Ensure the switch is in the off position before charging, picking up or carrying the appliance. Carrying the appliance with your finger on the switch or powering on the appliance with the switch on may cause accidents.

15. For the purposes of recharging the battery, only use the detachable supply unit provided with this appliance. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.

16. Disconnect the battery pack from the appliance before making any adjustments, changing accessories, or storing appliance. Such preventive safety measures reduce the risk of starting the appliance accidentally.

17. Under improper usage, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid comes into eye contact, seek medical help. Liquid ejected from the battery may cause irritation or burns.

18. Do not use the appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.

19. Do not expose the appliance to fire or excessive heat. Exposure to fire or temperatures above 266°F (130°C) may cause an explosion.

20. Follow all charging instructions and do not charge the appliance outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside of the specified range may damage the battery and increase the risk of fire.

21. Have servicing performed by a qualified repair person using only identical replacement parts. This will ensure that the safety of the product is maintained.

22. This appliance contains battery cells that are non-replaceable. Do not modify or attempt to repair the appliance or the battery pack except as indicated in the instructions for use and care.

23. Always turn off this appliance before connecting or disconnecting the motorized nozzle.

24. Do not charge or store the appliance outdoors or inside a car. Only charge, store or use the appliance in a dry indoor area where the temperature is higher than 39.2°F (4°C) but lower than 104°F (40°C). The charger is for indoor use only.

25. Use appliances only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.

26. When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other small metal objects, that can make a connection from one terminal to another. Shorting the battery terminals together may cause burns or a fire.

27. Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.

28. Use supply unit to charge Tineco battery ZB2451-6S1P-01A only.

29. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.

30. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

The TINECO PURE ONE S70 complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

• The battery contains materials that are harmful to the environment and must be removed from the appliance before it is discarded.

• When removing the battery, the appliance must be powered off.

• Batteries, chargers, accessories and packaging should be sorted for environmental friendly recycling. Do not put them into fire, water or soil. Do not dispose of batteries and chargers into household waste!

• If battery leakage contacts skin or clothing, immediately flush with water to avoid irritation and seek medical help.

A. Dust Sensor

B. Dustbin

C. Dustbin Release Button

D. Battery Release Button

E. Dust Empty Release Button

F. Power and Mode Switch

A. Brush Roller-tangled Indicator

B. Battery Status

C. Left Edge Cleaning Indicator

D. MAX Mode

E. ECO Mode

F. AUTO Mode

G. Air Channel-blocked Indicator

H. Dirt Monitoring Loop (Blue to red according to the dirt amount)

I. Right Edge Cleaning Indicator

To install the tube, insert it into the main body until it clicks into place.

To remove the tube, press the release button and pull it away from the main body.

To install the power brush, insert it into the end of the tube until it clicks into place.

To remove the power brush, press the release button and pull it away from the tube.

1. Each support tube has a securing clip on the back.

2. Ensure the Main Unit Holder and the Accessory Storage Holder are installed with openings facing forward.

3. Assemble from bottom to top: Main Base → Accessory Storage Holder → Main Unit Holder.

4. Make sure that each of the clips is secured in place before storing the vacuum cleaner.

• Before the first use, please charge the appliance for 4-5 hours in an area where the ambient temperature is between 39.2°F (4°C) and 104°F (40°C).

• Select an accessory and attach it to the appliance before use.

Press the Power and Mode Switch button to activate suction.

Press the same button again to switch between cleaning modes. The modes cycle as follows:

• Default: AUTO Mode

• First Press: ECO Mode

• Second Press: ECO Mode

Press the Dust Empty Release Button on the top of the machine to empty the contents into a trash receptacle. After emptying, close and click the dustbin flap back into place.

Note: Press the Dust Empty Release Button only when emptying the dust, do not press the button while in use.

1. Place the appliance on the Charging Stand.

2. Plug the adaptor into the charging port at the back of the Main Unit Holder.

3. Plug the adaptor into a wall outlet.

Warning:

• Only use the Tineco-provided adaptor to charge the appliance.

• To avoid trip hazards, please place the appliance securely on the charging dock, near a wall during charging.

• During long periods of not being used, store the appliance in a cool, dry place. Ensure the battery is fully charged every 3 months.

• Do not expose appliance to sunlight or freezing temperature. Recommended temperature range: 39.2°F (4°C)~104°F (40°C).

It is recommended to clean the dustbin and filters after each use.

1. Push the dustbin release button outward to detach the dustbin from the machine. Only release the dustbin during maintenance, not while the machine is in use.

2. Pull up to remove the mesh filter from the dustbin.

3. The mesh filter can be washed under cold running water. It must be completely dry before reinstalling.

4. After cleaning, install the clean filter back into the main body, then install the dustbin. To install the dustbin, first engage the hook on the front of the main unit, then push it fully into the locked position. You will hear a click sound when the dustbin is properly installed. To ensure it is secure, gently pull it outward to confirm the installation is complete.

It is recommended to wash the HEPA filter every 6 months and replace it every 24 months.

1. Pull out the HEPA filter for cleaning. Do not use the appliance without first installing the HEPA filter.

2. The HEPA filter can be washed under running water and must be completely dry before reinstalling.

To avoid dust accumulation which can affect cleaning performance, wipe the suction mouth with a damp cloth.

1. With the power off, rotate the knob on the roller end cover, then pull out the brush roller.

2. After removing the brush roller, gently clean the brush window, suction mouth and the row of plastic teeth.

3. Fully reinsert the brush roller into the brush window and rotate the knob clockwise until it clicks securely back into place.

Warning:

• The power brush contains electrical components which must not be soaked or washed with water.

• To reduce injury, do not touch the brush roller while the appliance is in working condition.