SUPER BRIGHT LEDS LPGD-XK100W-111WH-S (01) PDF MANUAL


Post questions, comments, reviews or errors in the comment box below.

Your File is Ready … Download PDF

CLICK HERE TO DOWNLOAD SUPER BRIGHT LEDS LPGD-XK100W-111WH-S (01) PDF MANUAL


PDF Content Summary: Important: Read all instructions prior to installation. LPGD Series LED Canopy/Parking Garage Light Surface Mounting Installation 1. Loosen 4 retaining screws and pull back plate from light. Once loose, detach safety cable. 2. Remove conduit plug, drill holes through back panel, and mount to junction box. Note: Any holes drilled in back plate will need to be properly sealed. 3. Connect wiring. 4. Reattach safety cable. 5. Place light over back plate and retighten four retaining screw until tight. Note: Screws will not thread in until flush, do not overtighten. 3.5 in [90 mm] 3.3 in [84 mm] 2.8 in [71 mm] 5 in mm] 3 inm] 8 inm] Rev Date: V0.1 07/01/2019 4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com 5yr User Manual Specifications Model LPGD-xK55W-111WH and LPGD-xK55W-111WH-S Wiring Diagram LPGD-xK100W-111WH and LPGD-xK100W-111WH-S Wattage 55 W 100 W Operating Voltage Range 100–277 VAC Light Distribution Type V Operating Temperature -40°–122° F(-40°–50° C) IP Rating IP65 Dimmable 1–10V on non-motion sensor models, 0–10 V on models equipped with preinstalled motion sensor (controlled through sensor only). Weight 4 lb (1.8 kg) 6.6 lb (3 kg) Line Neutral Ground Black L L N N GND GND White Dim (+) Dim (-) Green Note: Dimming function is not available on models equipped with motion sensor. Purple + + - - Gray LPGD-xK55W-111WH-S User Manual Important: Read all instructions prior to installation. LPGD Series LED Canopy/Parking Garage Light Conduit Installation 1. Loosen 4 retaining screws and pull back plate from light. Once loose, detach safety cable. 2. Remove desired conduit plug(s). 3. Attach conduit to back plate. Drill mounting holes through back plate for additional mounting support as needed. Note: Any holes drilled in back plate will need to be properly sealed. 4. Connect wiring. 5. Reattach safety cable. 6. Place light over back plate and retighten four retaining screw until tight. Note: Screws will not thread in until flush, do not overtighten. Pole/Pendant Mounting Installation 1. Loosen 4 retaining screws and pull back plate from light. Once loose, detach safety cable. 2. Remove conduit plug and attach pipe to back plate. 3. Connect wiring. 4. Reattach safety cable. 5. Place light over back plate and retighten four retaining screw until tight. Note: Screws will not thread in until flush, do not overtighten. Rev Date: V0.1 07/01/2019 4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com 5yr


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL

Leave a Reply