FREE ENGLISH SUNX GX-F8 (01) PDF USER GUIDE
FREE ENGLISH SUNX GX-F8 (01) PDF USER MANUAL
FREE ENGLISH SUNX GX-F8 (01) PDF OWNER GUIDE
FREE ENGLISH SUNX GX-F8 (01) PDF OWNER MANUAL
FREE ENGLISH SUNX GX-F8 (01) PDF REFERENCE GUIDE
FREE ENGLISH SUNX GX-F8 (01) PDF INSTRUCTION GUIDE
FREE ENGLISH SUNX GX-F8 (01) PDF REFERENCE MANUAL
FREE ENGLISH SUNX GX-F8 (01) PDF INSTRUCTION MANUAL
FREE ENGLISH SUNX GX-F8 (01) PDF OPERATING INSTRUCTIONS
CLICK HERE TO DOWNLOAD SUNX GX-F8 (01) PDF MANUAL
If this is not the document you want for this product, click here to see if we have any other documents for this product.
Can this product be used as a sensing device for personnel protection?
Never use this product as a sensing device for personnel protection.
What type of products should be used for personnel protection sensing?
In case of using sensing devices for personnel protection, use products which meet laws and standards, such as OSHA, ANSI or IEC etc., for personnel protection applicable in each region or country.
What is the intended use for this product?
This product has been developed / produced for industrial use.
Does the product output have short-circuit protection?
The output does not incorporate a short-circuit protection circuit. Do not connect it directly to a power supply or a capacitive load.
Is there a delay required after powering on the product?
Do not use during the initial transient time (50ms) after the power supply is switched on.
What are the specifications for cable extension?
Extension up to total 100m is possible with a 0.3mm², or more, cable.
What are the mounting instructions for this product?
In case of mounting this product, use a M3 truss head screw, and the tightening torque should be 0.7N·m or less.
How should the NPN output be connected?
For NPN output configuration:
The Brown wire connects to +V.
The Black wire is the Output. The Load should be connected between the Black (Output) wire and +V.
The Blue wire connects to 0V.
The operating voltage is 12 to 24V DC (+10% / -15%).
The maximum output current is 100mA.
How should the PNP output be connected?
For PNP output configuration:
The Brown wire connects to +V.
The Black wire is the Output. The Load should be connected between the Black (Output) wire and 0V.
The Blue wire connects to 0V.
The operating voltage is 12 to 24V DC (+10% / -15%).
The maximum output current is 100mA.
CLICK HERE TO DOWNLOAD SUNX GX-F8 (01) PDF MANUAL