SUNBEAM FEEL PERFECT EP5000 (01) PDF MANUAL


Post questions, comments, reviews or page errors in the comment box below.

Your File is Ready … Download PDF

CLICK HERE TO DOWNLOAD SUNBEAM FEEL PERFECT EP5000 (01) PDF MANUAL


PDF Content Summary: Feel Perfect Therapeutic Heat Pad Instruction Booklet EP5000 Please read these instructions carefully and retain for future reference. Heading Sub Heading Body copy with not indent applied. • Bullet copy Bullet copy Bullet copy Bullet copy Bullet copy Bullet copy Bullet copy Bullet copy 2 Contents Sunbeam’s Safety Precautions 2 Features of your Heat Pad 4 Using your Heat Pad 6 Care and cleaning 7 Important instructions – retain for future use. Sunbeam’s Safety Precautions

Sunbeam is very safety conscious when designing and manufacturing consumer products, but it is essential that the product user also exercise care when using an electrical appliance. Listed below are precautions which are essential for the safe use of an electrical appliance: • Read carefully and save all the instructions provided with an appliance. • Always turn the power off at the power outlet before you insert or remove a plug. Remove by grasping the plug - do not pull on the cord. • Turn the power off and remove the plug when the appliance is not in use and before cleaning. • Do not use your appliance with an extension cord unless this cord has been checked and tested by a qualified technician or service person. • Always use your appliance from a power outlet of the voltage (A.C. only) marked on the appliance. • Close supervision is necessary when your appliance is being used by children or infirm persons. • Young children should be supervised to ensure that they do not play with the appliance. • Never leave an appliance unattended while in use. • Do not use an appliance for any purpose other than its intended use. • Do not place an appliance on or near a hot gas flame, electric element or on a heated oven. Do not place on top of any other appliance. • Do not let the power cord of an appliance hang over the edge of a table or bench top or touch any hot surface. • Do not operate any electrical appliance with a damaged cord or after the appliance has been damaged in any manner. If damage is suspected, return the appliance to the nearest Sunbeam Appointed Service Centre for examination, repair or adjustment. • For additional protection, Sunbeam recommend the use of a residual current device (RCD) with a tripping current not exceeding 30mA in the electrical circuit supplying power to your appliances. • Do not immerse the appliance in water or any other liquid unless recommended. • Appliances are not intended to be operated by means of an external timer or separate remote control system.

If you have any concerns regarding the performance and use of your appliance, please visit sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood. 2 Safety Precautions for your Heat Pad

• Do not switch the heat pad on if moist or wet. • Do not use pins, needles, safety pins or other sharp items on your heat pad. • Examine periodically for signs of wear or damage on the heat pad cords. If there are such signs, or the heat pad has been misused, return it to an authorised service agent for inspection. • Only use your heat pad with the controls supplied or marked equivalent. • Not to be used by very young children (0-3 years), infirm persons, or persons insensitive to heat. • Children under the age of three are not to use this appliance due their inability to react to overheating. • The appliance is not to be used by young children over the age of three unless the controls have been pre-set by a parent or guardian, or unless the child has been adequately instructed on how to operate the controls safely. • Ensure that the heat pad is switched off and unplugged after use. • Do not use on varicose veins. • Do not use if you have skin disorders or open wounds. • Do not use on sensitive skin or areas insensitive to heat. • If you are pregnant or suffer from diabetes consult your health care practitioner before using. • Do not use if you have tuberculosis, tumours, phlebitis, haemorrhages or thrombosis. • Do not use if you have a pace maker fitted. • Do not use outdoors. • Do not use when intending to sleep. • Keep out of the reach of children. • This heat pad is not intended for use in hospitals. • If appliance is used on an adjustable bed, check that the heat pad and cord do not become trapped or rucked, for example in hinges. • When storing the appliance allow it to cool down before folding. • Do not crease the appliance by placing items on top of it during storage. • Should your appliance suffer a thermal or fuse link rupture (normally identified when the heat pad stops heating) please return it to the manufacturer or agent for repair or replacement. • This appliance must not be used by persons insensitive to heat and other very vulnerable persons who are unable to react to overheating. • Do not use if folded or crumpled. • Use only with the cover supplied. • Do not use the heat pad to heat animals.

Important instructions – retain for future use. If you have any concerns regarding the performance and use of your appliance, please visit sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood. Care Label Symbols Attention Instruction Booklet - Please read the instructions thoroughly before use 3 Features of your Heat Pad EP5000 Controller

Temperature Setting Button Power Button Controller 1. Low - Up to 30 degrees 2. Mild - 31 to 33 degrees 3. Medium - 34 to 36 degrees 4. High - 37 to 39 degrees 5. Rapid heat up only Standby Indicator

4

Sleeve Controller Connector (on the underside of the pad, not shown) 5

Using your Heat Pad

Using your Heat Pad • Remove all packaging • Ensure the power button on the controller is in the off position (not pressed in) • Connect the controller to the heat pad • Insert the plug into the power outlet and switch on • The heat pad will automatically default to setting 5 for rapid heating, and begin to heat up. • Setting 5 is for heat up only. Do not use this setting for continuous or overnight use. • Place the heat pad behind your back or neck whilst sitting or lying on a couch, chair or bed. This versatile heat pad is a cozy and comfortable addition to any lounge or bedroom. • You can use the sleeve to secure the heat pad to a chair back or around your arm or leg. • To reduce the warmth, switch to a lower heat setting. For any continuous or overnight use, select from settings 1-4 only. Note: If the blue standby indicator light on the controller begins to flash, turn the controller off and check that the controller is properly connected to the heat pad. If the blue standby indicator continues to flash after turning the controller back on, contact your local Sunbeam Service Agent. Auto off function • The heat pad features an auto shut off. After 3 hours operation, the blue standby indicator light will show to indicate the heat pad has switched itself off.

6 Care and Cleaning

This Feel Perfect heat pad features waterproof heating elements, making them fully immersible and safe to wash by hand or machine. Before cleaning your heat pad, ensure that the controls are unplugged from the heat pad. Spot cleaning Sponge the affected area using a neutral wool detergent or mild soap flakes mixed with lukewarm water. Sponge twice with clean water to remove detergent. Remove excess water by compressing the wet area between two towels. Hand washing Wash the heat pad in lukewarm water with a neutral wool detergent or mild soap flakes. Soak for five minutes, then gently squeeze the soapy water through the fabric. Rinse thoroughly in clean, lukewarm water then drain excess water from the heat pad. Do not wring. Machine washing Take your heat pad to a commercial laundry or wash in a domestic washing machine. Wash on WOOL or DELICATES cycle with a neutral wool detergent or mild soap flakes, below 40°C. Do not use high speed or extra spin cycles. Line drying Drape the heat pad across several lines of your clothesline. Do not use pegs on the wired areas. Do not dry with a hairdryer or heater. Ensure that the heat pad and control sockets are completely dry before using again. Machine drying Tumble dry your heat pad on LOW setting for 15 minutes MAXIMUM. Smooth the heat pad by gently pulling any creases out of the fabric. Line dry to ensure the heat pad and control sockets are completely dry before use. Do not dry with a hairdryer or heater. Storing your heat pad Roll or fold your heat pad loosely and store in a blanket bag or the bag it was supplied in. Avoid pressing sharp creases into the heat pad. Do not place heavy items on top of your heat pad when storing. Checking your heat pad Examine the heat pad frequently for signs of wear or damage. If there are any such signs or if the heat pad has been misused, return it to your nearest Sunbeam Service Agent prior to any further use. 7

Notes 2 Year Warranty This Sunbeam product is covered by a 2 year replacement or repair warranty, which is in addition to your rights under the Australian Consumer Law (if your product was purchased in Australia) or New Zealand Consumer Guarantees Act (if your product was purchased in New Zealand).

Should you experience any difficulties with your product during the warranty period, please contact our customer service line for advice on 1300 881 861 in Australia, or 0800 786 232 in New Zealand. Alternatively, you can send a written claim to Sunbeam to: Australia Units 5 & 6, 13 Lord Street Botany NSW 2019 Australia New Zealand Level 6, Building 5, Central Park, 660-670 Great South Road, Greenlane, Auckland Upon receipt of your claim, Sunbeam will seek to resolve your difficulties or, if the product is defective, advise you on how to obtain a replacement or refund. To assist us in managing warranty claims, we recommend you register your product as soon as practicable after purchase by creating a MySunbeam account on our website and send a copy of your original receipt to Sunbeam. In order to make a claim under our warranty, you must have the original proof of purchase documentation for the product and present it when requested . Should your product develop any defect within 2 years of purchase because of faulty materials or workmanship, we will replace or repair it, at our discretion, free of charge. A product presented for repair may be replaced by a refurbished product of the same type rather than being repaired. Refurbished parts may be used to repair the product. Our replacement or repair warranty only applies where a defect arises as a result of faulty material or workmanship during the warranty period. Your warranty does not cover misuse or negligent handling (including damage caused by failing to use the product in accordance with this instruction booklet), accidental damage, or normal wear and tear. Your warranty does not: • cover freight or any other costs incurred in making a claim, consumable items, accessories that by their nature and limited lifespan require periodic renewal (such as filters and seals) or any consequential loss or damage; or • cover damage caused by: - power surges, power dips, voltage supply problems, or use of the product on incorrect voltage; - servicing or modification of the product other than by Sunbeam or an authorised Sunbeam service centre; - use of the product with other accessories, attachments, product supplies, parts or devices that do not conform to Sunbeam specifications; or - exposure of the product to abnormally corrosive conditions; or • extend beyond 3 months if the product is used in commercial, industrial, educational or rental applications. The benefits given to you by our warranty are in addition to other rights and remedies under law in relation to the product. In Australia our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. Our goods also come with guarantees that cannot be excluded under the New Zealand Consumer Guarantees Act. If your warranty claim is not accepted, we will inform you and if requested to do so by you, repair the product provided you pay the usual charges for such repair. You will also be responsible for all freight and other costs. Should your product require repair or service after the warranty period, contact your nearest Sunbeam service centre. For a complete list of Sunbeam’s service centres, visit our website or call our customer service line for advice on 1300 881 861 in Australia, or 0800 786 232 in New Zealand.

Need help with your appliance? Contact our customer service team or visit our website for information and tips on getting the most from your appliance. In Australia Visit sunbeam.com.au Or call 1300 881 861 In New Zealand Visit sunbeam.co.nz Or call 0800 786 232 is a registered trademark. ‘Feel Perfect’ is a registered trademarks of Sunbeam Corporation. Made in China. Due to minor changes in design or otherwise, the product may differ from the one shown in this leaflet. © Copyright. Sunbeam Corporation Limited 2013. ABN 45 000 006 771 Units 5 & 6, 13 Lord Street Botany NSW 2019 Australia Level 6, Building 5, Central Park 660-670 Great South Road Greenlane, Auckland New Zealand Sunbeam Corporation is a division of GUD Holdings Ltd. 11/13


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL

Leave a Reply