SONY WH-1000XM6 YY2984 (01) PDF Document

The model and serial numbers to be recorded are located in the places indicated by Fig. A in the reference guide.

Please follow these safety precautions for the batteries of your SONY WH-1000XM6 YY2984:

• Do not expose the batteries (battery pack or batteries installed) to excessive heat, such as sunshine, fire or the like, for a long time.

• Do not subject the batteries to extreme low temperature conditions that may result in overheating and thermal runaway.

• Do not dismantle, open, or shred secondary batteries.

• In the event of a secondary battery leaking, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice.

• Secondary batteries need to be charged before use. Always refer to the manufacturer’s instructions or product manual for proper charging instructions.

• After extended periods of storage, it may be necessary to charge and discharge the secondary batteries several times to obtain maximum performance.

• Dispose of properly.

To charge your SONY WH-1000XM6 YY2984 headset, use the supplied USB Type-C® cable and a commercially available USB AC adaptor. Connect the USB AC adaptor to the headset using the USB Type-C cable, then connect the USB AC adaptor to an AC outlet. After charging is complete, disconnect the USB Type-C cable.

Yes, please take the following precautions:

• While connecting the USB cable, do not apply excessive force to the connection part.

• When connecting or disconnecting the USB cable, do not apply excessive force, such as by pulling the cable, and connect or disconnect the connector straight to the port to be connected.

• If the USB cable connector is deformed, such as by it being bent, stop use immediately.

• Never insert the USB plug when the unit or charging cable is wet. If the USB plug is inserted while the unit or charging cable is wet, a short circuit may occur due to liquid or foreign matter, and cause abnormal heat generation or malfunction.

The SONY WH-1000XM6 YY2984 is not waterproof. If water or foreign matter enters the unit, it may result in fire or electric shock. If water or foreign matter enters the unit, stop use immediately and consult your nearest Sony dealer. In particular, be careful in the following cases:

• When using the unit near a sink or liquid container. Be careful that the unit does not fall into a sink or container filled with water.

• When using the unit in the rain or snow, or in humid locations.

• When using the unit while you are perspiring. If you touch the unit with wet hands, or put the unit in the pocket of a damp article of clothing, the unit may get wet.

The voice guidance can be heard from the SONY WH-1000XM6 YY2984 in the following situations:

• When the remaining battery level is low and recharge is recommended: “Low battery”

• When automatically turning off due to low battery: “Battery is empty”

• When checking the remaining battery level by pressing the POWER button while the unit turns on: “Battery fully charged” / “Battery about 90%” / “Battery about 80%” / “Battery about 70%” / “Battery about 60%” / “Battery about 50%” / “Battery about 40%” / “Battery about 30%” / “Battery about 20%” / “Battery about 10%”

• When entering pairing mode: “Pairing”

• When the USB cable is connected to the headset and a charging error or temperature error occurs during use: “Charging stopped. To resume charging, disconnect the USB cable and wait before trying again”

Yes, please observe the following precautions regarding BLUETOOTH® communications:

• Microwaves emitting from a Bluetooth device may affect the operation of electronic medical devices. Turn off this unit and other Bluetooth devices in the following locations, as it may cause an accident: in hospitals, near priority seating in trains, locations where inflammable gas is present, near automatic doors, or near fire alarms.

• The audio playback on this unit may be delayed from that on the transmitting device, due to the characteristics of Bluetooth wireless technology. As a result, the sound may not be in sync with the image when viewing movies or playing games.

While liquid such as water or sweat, or foreign matter such as dust is attached to the USB Type-C cable or USB port, charging the unit may cause serious accidents such as burns or injuries due to fire, electric shock, heat generation or ignition, or can be the cause of a malfunction.

Note the following when you use the unit while charging:

• If you feel any abnormality, stop using immediately.

• Check that there is no dust or foreign matter inside.

• If the USB cable or port gets wet due to liquid such as drinking water or sweat while charging, disconnect the USB cable from the connected device immediately to stop charging.

• After use, remove the headphones slowly.

• Because the headphones achieve a tight seal over the ears, forcibly pressing them against your ears or quickly pulling them off can result in eardrum damage. When wearing the headphones, the speaker diaphragm may produce a click sound. This is not a malfunction.

• When you use the unit as wired headphones, use the supplied headphone cable only. Make sure that the headphone cable is firmly inserted.

• When disconnecting the cable, pull it out by the plug, not the cable. Otherwise the cable may break.

• When connecting the cable, make sure to fully insert the plug into the jack. If the plug is not fully inserted, the sound may not be output.

If you experience discomfort while using the unit, stop using it immediately. Do not apply weight or pressure to the unit for long periods, including when it is stored, as it may cause deformation.

If you use the unit when the air is dry, you may experience discomfort due to static electricity accumulated on your body. This is not a malfunction of the unit. You can reduce the effect by wearing clothes made of natural materials that do not easily generate static electricity.

USB AC adaptor:

A commercially available USB AC adaptor capable of supplying an output current of 1.5 A or more.

Commercially available AC adaptor compatible with USB PD (USB Power Delivery):

It is recommended that you use the adaptor whose output is 5 V/2 A or 9 V/3 A.

We do not guarantee the operations with all the devices compatible with USB PD.