Free English SONY SS-B3000 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD SONY SS-B3000 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What should be done before connecting the SONY SS-B3000 speaker system?
Before connecting, turn off the amplifier or receiver to avoid damaging the speaker system.
What type of amplifier or receiver is recommended for the SONY SS-B3000?
This speaker system is driven best by an amplifier or receiver rated as per the wattage indicated in the specification section. A low-powered amplifier or receiver could result in signal clipping, which could result in tweeter burn-out. Therefore, it is recommended to use an amplifier or receiver with sufficient power rating.
What precaution should be taken regarding input power for the SONY SS-B3000?
Avoid driving the speaker system continuously with a wattage exceeding the maximum input power of each speaker.
Are there user-serviceable parts inside the SONY SS-B3000?
Do not attempt to open the enclosure or remove speaker units. There are no user-serviceable parts inside.
What items should be kept away from the SONY SS-B3000 due to magnetism?
Keep recorded tapes, watches, and personal credit cards using magnetic coding away from the speaker system.
How should the SONY SS-B3000 cabinet be cleaned?
Periodically wipe the cabinet with a soft cloth. Do not use any type of scouring powder, abrasive pad or solvent.
How should the grill net be installed on the SONY SS-B3000?
Be sure to install the grill net in the correct direction.
What are the guidelines for placing the SONY SS-B3000 speakers?
Please note that room acoustics can often produce large difference in the sound for small changes in speaker placement.
Set up your speaker system on a hard, flat place.
Place the speaker system against a hard wall with its back about 10 cm (4 in.) away from a wall. The proportion of bass increases as you move a speaker close to intersecting room surfaces (wall and wall, etc.).
Place the right and left speakers in a similar acoustic environment.
It is recommended that the speaker/listener relationship be an equilateral triangle.
What are the specifications of the SONY SS-B3000?
| Speaker system | 3-way, magnetically shielded |
| Speaker units | Woofer: 20 cm (8 in.), cone type Midrange: 8 cm (3 1/4 in.), cone type Tweeter: 2.5 cm (1 in.), balanced dome type |
| Enclosure type | Bass reflex |
| Rated impedance | 8 ohms |
| Maximum input power | 120 watts |
| Sensitivity level | 88 dB (1 W, 1 m) |
| Frequency range | 50 Hz – 50,000 Hz |
| Dimensions (w/h/d) | Approx. 240 × 530 × 263 mm (9 1/2 × 20 7/8 × 10 3/8 in.) including front grille |
| Mass | Approx. 6.5 kg (14 lb 6 oz) |
| Supplied accessory | Speaker cord (2) |
CLICK HERE TO DOWNLOAD SONY SS-B3000 (01) PDF DOCUMENT