SONY CBK-12C3621 (01) PDF Document

The SONY CBK-12C3621 is a camera extension system cable used to connect the CBK-3621XS. It provides an extension of 12 m (39.4 ft) when attached to the CBK-3621XS. In addition to the imager signal, it relays 24 V power to the imager block which can be used to power a lens servo.

Please observe the following precautions when using the SONY CBK-12C3621:

• Using the unit with dirt or dust adhering to the connector between the camera body and sensor block may cause a failure or malfunction. When storing, be careful not to let dirt accumulate.

• Do not crush, bend, or damage the cable.

• Be careful when coiling and installing the cable so that the cable is not subject to strong twisting.

• The minimum coil diameter for guaranteed cable operation is 45 mm (1 13/16 inches) or longer.

If the SONY CBK-12C3621 is suddenly taken from a cold to a warm location, or if ambient temperature suddenly rises, moisture may form on the outer surface of the unit and/or inside of the unit. This is known as condensation. If condensation occurs, turn off the unit and wait until the condensation clears before operating the unit. Operating the unit while condensation is present may damage the unit.

Failure to follow the following precautions may result in death or serious injury due to fire or electric shock:

• Pay attention to your surroundings when shooting. Shooting without being aware of your surroundings may result in accidents or injuries.

• Do not modify or damage the cord. Damage to the cord may cause a malfunction or electric shock.

• Do not allow water or foreign objects to enter the unit. Water or foreign objects entering the unit may cause a fire, electric shock, or injury. If water or foreign objects enter the unit, immediately turn off the unit, remove the power cord and connection cords, and contact your Sony service or sales representative.

• If the unit becomes wet, it may cause an electric shock or fire due to electrical leakage.

Failure to follow these precautions may result in injury or damage to surrounding objects:

• Do not install in locations exposed to oil smoke, steam, humidity, or dust. Installing the unit in such locations may result in fire or electric shock.

• Install the unit in a stable location. Placing the unit on an unstable surface, such as a wobbly stand, may cause the unit to fall and result in injury.

• Arrange the cords appropriately. Tripping over the power cord or connection cables may cause the unit to fall and result in injury.

• Do not disassemble or modify the unit. Disassembling or modifying the unit may cause a fire, electric shock, or injury. For internal inspection or repairs, contact the store where you purchased the unit or your Sony service representative.

To ensure connectors are firmly connected:

• Do not insert any metallic objects into the connectors (connection terminals). Doing so may cause a short-circuit between pins and result in a fire or malfunction.

• Insert connectors straight in when connecting cables. Inserting connectors at an angle may cause a short-circuit between pins and result in a fire or malfunction.

• If a connector has a locking spring or screw, use it to securely fasten the connector in place. This will prevent poor connection.

• Connect connectors with a ground wire to ground.

Yes, please note the following environmental restrictions:

• This equipment is not suitable for use in locations where children are likely to be present.

• This apparatus shall not be used in the residential area.

• Operation of this equipment in a residential environment could cause radio interference.

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

The use of optical instruments with this product will increase eye hazard.

The SONY CBK-12C3621 comes with the following supplied accessories:

• Operating Instructions (1)

• Warranty (1)