SIP 05613 (01) PDF MANUAL

The symbols used throughout this manual indicate the following:

Danger / Caution: Indicates risk of personal injury and/or the possibility of damage.

Warning: Risk of electrical injury or damage!

Note: Supplementary information.

Please read the following instructions carefully, failure to do so could lead to serious personal injury and / or damage to the fan.

When using your fan, basic safety precautions should always be followed to reduce the risk of fire, electric shock, personal injury and / or damage to the fan.

Read all of these instructions before operating the fan and save this user manual for future reference.

The fan should not be modified or used for any application other than that for which it was designed; It was designed to safely and quietly move air in large volumes.

Before operating the fan always check no parts are broken, that all screws are completely tight and that no parts are missing.

Always operate the fan safely and correctly.

Read and understand the owner’s manual and labels affixed to the fan. Learn its applications and limitations, as well as the potential hazards specific to it.

Do not use your fan in damp or wet locations, or expose it to rain. Always provide adequate space around the drum fan.

Always watch what you are doing and use common sense when placing and operating the fan.

Disconnect the fan from the mains supply when not in use.

Never leave the fan unattended during operation.

Never pull the mains lead to remove the plug from the mains socket, or to move the fan from place to place. Keep the mains lead away from heat, oil and sharp edges. If the mains lead is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid unwanted hazards.

Unapproved and untested parts may be dangerous and will invalidate the warranty.

Check that the fan is in sound condition and good working order. Take immediate action to repair or replace damaged parts.

Only operate on a level and stable surface.

Do not allow untrained persons to operate the fan and do not operate the fan without all covers etc. correctly fitted.

Do not expose the fan to water spray, rain, dripping water or moisture of any kind.

Do not leave the fan unattended when in use. Switch the fan off and unplug from the mains supply before leaving the work area.

Do not allow children or animals near the drum fan, particularly when in use.

Ensure that the drum fan is correctly turned off when not in use and store in a safe, dry area, out of reach of children.

Keep all combustible materials away from this drum fan.

Never stand on the fan.

Do not dismantle or tamper with the fan, this may be dangerous and will invalidate the warranty.

Never leave the fan unattended and ensure that children and pets are kept a safe distance from the fan.

Turn the fan off and disconnect it from the mains supply when moving from one location to another.

Turn the fan off and disconnect it from the mains supply when carrying out any repairs, maintenance or cleaning.

Do not use petrol or other corrosive liquids for cleaning as they may damage the fan or outer casing / grill.

Do not operate the fan near an open window, such as on a window sill; rain or moisture may create an electrical hazard.

Never modify the fan in any way.

Never operate the fan without all guards in place.

Before each use; always check that the moving parts move freely and do not catch or bind.

Stop operation immediately if abnormalities are noticed.

Always clear the surface around where the fan is to be used to avoid unwanted dust or debris being pulled through the fan.

If a problem with the drum fan is experienced, or if the mains lead or plug become damaged, contact your distributor for repair.

If the drum fan is used in a place of work all rules and laws etc. relating to the use of portable electrical appliances should be followed.

Understand the operating environment; Before each use the operator should assess, understand and where possible reduce the specific risks and dangers associated with the operating environment. Bystanders should also be made aware of any risks associated with the operating environment.

The warnings and cautions mentioned in this user manual can not cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be applied.

It is the responsibility of the owner and the operator to read, understand and comply with the following:

You must check all electrical products, before use, to ensure that they are safe.

You must inspect power cables, plugs, sockets and any other connectors for wear or damage.

You must ensure that the risk of electric shock is minimised by the installation of appropriate safety devices; A residual current circuit Breaker (RCCB) should be incorporated in the main distribution board.

We also recommend that a residual current device (RCD) is used. It is particularly important to use an RCD with portable products that are plugged into a supply.

Use only the electrical power (voltage and frequency) specified on the model plate of the drum fan.

Use only a three-prong, grounded (earthed) outlet.

Do not touch, or operate the fan when your hands are wet.

Those who are not qualified electricians / engineers should not disassemble, repair or rebuild the fan.

Do not unplug the fan by pulling the mains lead. Unplug by holding the plug.

Do not use the fan when there is damage to the mains lead or plug.

Do not use the fan close to the fires.

To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.

Do not use the fan outdoors.

Always check all guards to make sure they are secure before starting the fan.

Never insert fingers or any other object/s through the grill guard when the fan is in operation.

If an extension lead is required in order to reach the mains supply; ensure that this too is rated for the correct voltage and fuse rating.

The cross section of the extension lead should be checked so that it is of sufficient size so as to reduce the chances of voltage drops.

To assemble the fan, follow these steps:

1. Line up the 2 x stand brackets with the fan stand.

2. Insert the fan head into the stand.

3. As you slide the fan head down, press the release buttons on the stand brackets and allow them to “click” into place to secure.

This SIP drum fan is fitted with a standard 230v ~ 13 amp type plug. Before using the drum fan, inspect the mains lead and plug to ensure that neither are damaged. If any damage is visible have the drum fan inspected / repaired by a suitably qualified person. If it is necessary to replace the plug a heavy duty impact resistant plug would be preferable.

The wires for the plug are coloured in the following way:

Yellow / green = Earth

Blue = Neutral

Brown = Live

As the colours of the wires may not correspond with the markings in your plug, proceed as follows: The wire which is coloured blue, must be connected to the terminal marked with N or coloured black. The wire which is coloured brown, must be connected to the terminal, which is marked L or coloured red. The wire which is coloured yellow / green should be connected to the terminal which is coloured the same or marked with the earth symbol.

Always secure the wires in the plug terminal carefully and tightly. Secure the cable in the cord grip carefully.

Never connect live or neutral wires to the earth terminal of the plug. Only fit an approved plug with the correct rated fuse. If in doubt consult a qualified electrician.

Always make sure the mains supply is of the correct voltage and the correct fuse protection is used. In the event of replacing the fuse always replace the fuse with the same value as the original.

To operate the fan, follow these instructions:

Tilt the fan head upward or downward for your desired direction of air flow.

The fan has 3 different speed settings:

0 — Stop

1 — Low

2 — Middle

3 — High

To start the fan, turn the switch to the desired position (1, 2 or 3).

To stop the fan running, turn the switch to “0”.

Never run this fan whilst it’s raining, or in any damp or wet locations, and never place it on the window sill.

Item No.	05613
Supply	230V~50Hz
Power	111 Watts
Fan Ø	20″ (508mm)
No. of Speed Settings	3
Protection	IP20

The following items are included:

1x Drum Fan.

1x Stand.

1x Instruction Manual.

If any of the above are missing or damaged, contact your distributor immediately.

The main parts of the drum fan are as follows:

Ref. No.	Description	Ref.	Description
1.	Front Guard	F.	Stand
2.	Fan Blade	G.	Mains lead
3.	Bracket	H.	Foot
4.	Drum Body	I.	Stand bracket
5.	Rear Guard
6.	Motor
7.	Switch Cover
8.	Switch
9.	Switch Flange
10.	Mains Lead

Additionally, other parts shown in the diagram include:

A. Fan blade

B. Front guard

C. Rear Guard

D. Carrying handle

E. Speed control knob